
UNSOLVED
M
manjunath_rames
3 Posts
0
1389
February 15th, 2010 02:00
Resume Fault in Clariion CX4 SPE
Hi Friends,
After initialized the Clariion SPE ,i got the following error :
| Enclosure SPE | Faulted |
| Enclosure SPE | Resume fault |
When i searched about this error in Navisphere Manager Release notes i got the below explanation:
| Navisphere Manager | SP A and SP B show inconsistent information regarding resume fault information. 211775 Frequency of occurrence: Rarely under a rare set of circumstances. Severity: Low | SP A and SP B show inconsistent information regarding resume fault information. Navisphere Manager reports device faults on the A side but does not report expected faults on the B side. | The worst fault condition reported by either SP is the accurate faulted resume information. Exists in versions: 6.24.0.6.14 6.26.0.2.9 6.26.20.1.19 6.28.0 |
But iam not understood what is resume fault and what they are suggesting in this Explanation.... Guys if anybody faced this same error
please suggest me what i need to do?
Any workaround is there to solve this or i need to install any patch to solve this resume faulty...?
Regards,
C.DEEBAN
Responses (1)
Solutions (0)

RRR
6 Operator
•
5739 Posts
190
0
Posted February 15th, 2010 02:00
I've seen faults after initialising a Clariion for the first time. After the SPS's were fully loaded, faults went away (restarting Navisphere Manager also helps, since it seems as if the local java cache as well as the interface itself do not display the correct information). I even saw an error (forgot to note which one) after initialising 2 CX3-40's and those wouldn't go away. I rebooted both sp's and everything was just fine