If your MX5016s storage sled is not being detected by the MX7000 chassis, it likely means there's an issue with the SAS switch configuration, the storage controller in your compute sleds, or a potential cabling problem. I would start with checking that the MX5016s is properly connected to the MX5000s SAS switch within the MX7000 chassis, and ensure the compute sleds have the necessary storage controller configured to access the MX5016s drives. I would also take the time to ensure that everything is up-to-date as well.
Let me know what you see.
DELL-Chris H
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!
Thank you very much for your help and suggestions. I have checked the physical connections between the MX5016s and the MX5000s, and they seem correct.
However, I noticed that the expansion modules (SAS expanders) of the MX5016s are not detected by the chassis, which could explain why the blades cannot detect the drives, even though the drives are visible in OpenManage Enterprise (OME) of the chassis with the status “assigned”.
This makes me think that the problem might be due to a malfunction of the expansion modules or a potential issue with the SAS paths between the chassis and the blades.
DELL-Chris H
7 Practitioner
•
9682 Posts
•
48046 Points
0
1
Posted March 5th, 2025 20:58
DELL-Chris H
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!