Dell M610 blade does not power up on M1000e chassie
The M1000e Blade Enclouse had 16 slots. When any M610 or M600 blade is inserted in one particular slot, it does not successfully power up. The green power light just blinks on the blade and on the Dell Chassis Management Controller, it just says the device is initializing. Blades in other slots power up fine.
So it's just that one slot that's not correctly posting your blade servers, correct? If that's the case, you could have a bad slot. You may want to open up a support case.
Kong Yang
180 Posts
4039
0
Posted November 21st, 2011 12:00
So it's just that one slot that's not correctly posting your blade servers, correct? If that's the case, you could have a bad slot. You may want to open up a support case.