UNSOLVED

DJMC117

updated

11 years ago

D

DJMC117

1 Rookie

•

26 Posts

0

2048

October 28th, 2015 04:00

SANCopy from CX310 to VNX5400

Hi,

I have a CX310 which is currently using all SP ports, I want to migrate to a new VNX using SAN Copy push from the CX to the VNX.

All my front end ports on the CX are zoned to hosts.  Is it enough to create a new zone which will contain only the CX310 and VNX ports, no hosts, or must I have SP ports physically dedicated to SAN Copy, ie removed from all hosts zones?

I hope this makes sense.

Thanks in advance.

D

  • SameerKulkarni1

    2 Intern

    •

    37 Posts

    659

    0

    Posted October 28th, 2015 07:00

    Hello,

    you can create a new zone with only CX and VNX ports in that, and it should work too with shared bandwidth/workload on those ports by host and SANCOPY services, but its highly recommended to keep dedicated ports for SANCOPY.

    sharing load means, it may take much more time then expected to migrate and most importantly, the host would also experience increase in response time. and if the hosts using these ports are IO intensive, it's not a good idea to share work load on them.

    hope this helps,

    Sameer

  • dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    659

    0

    Posted October 28th, 2015 18:00

    I use SANCopy on ports with hosts connected but as mentioned above be careful , use pace to your advantage.

  • 659

    0

    Posted October 30th, 2015 05:00

    dedicated fc port from both storage ,It is recommended for sancopy  .no ther host should not attach or zone with this port while san copy is configured.after san copy those ports can be used for other host for zone .

    but before doing those activity make sure failover -takeover mode is active ,and be careful while san copy because by mistake if lun no is wrong u r data can be lost .so please take backup b4 doing this activity .u will be in safe side .

  • dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    659

    0

    Posted October 30th, 2015 12:00

    what is "failover" and "takeover" in SANCopy ?

  • 659

    0

    Posted November 2nd, 2015 22:00

    Hi dynamox,

    Here i tried to made him understand by writing failover and takeover is since he will make empty one port from both the storage .but if those ports are used by any host and if those host are connect only those which he will make empty then server will lost connectivity.I ope u understand what i mean to say here.