Just need some clarification around installing and configuring PowerPath and Unisphere Host Agent for Windows 2008 R2 Operating System.
Do I need to install both PowerPath and Unisphere Host Agent?
Under Connectivity Status, when I look at the Host Name there is no Initiators entries? But they did appear yesterday and I thought I will take some time for host appear as Managed therefore left it overnight.
However, when login into Windows OS I can still see all the drives which are presented from SAN.
You can use non-EMC Multi-Pathing solutions, though I will say EMC is the best and easiest to configure. This gives you native capability yo use ALUA; a good thing.
The host agent is the piece that communicates the Disk/Lun/SAN details between the Host and the Array. It is also responsible for Host Based Self Registration which is a major time saver.
Be sure to use the AgentID.txt file settings to define the Host. (FDQN on one line and IP on the other)
Be sure to use and Agent.config file to define the array conenctions (I find this easier to have one file pre-defined and just copy it).
Your issue above is probably related to the AgentID.txt file. Give it a try.
You AgentID.txt file needs to look like:
hostname.int.asurion.com
10.10.10.10
You will place that file in the location: C:\Program Files (x86)\EMC\HostAgent
Once it is there, restart the host agent service. (Navisphere Agent)
I can't see the connectivity status page so I cannot be sure, but with PP not showing both HBAs, that means one of two things.
The HBAs (WWNs) are not properly registered (logged in and in a storage group)...
The Second HBA is not Zoned in the Fiber Fabric or has no path to the Storage Array.
Go into the connectivity status of the Array and check all the initiators (even the ones in existing hosts) and see if the WWNs for the second HBA are registered to the array. If they are, verify they are in the correct host. If not, remove them from the host they are attached to (possible these HBAs were in another host or previously connect to the Array?) and clean them up -- you may have to de-register them. Then once that is done, re-run the host agent, and try again. You could also use the UniSphere/NaviSphere Server Utility to manually register the array (first radial option once you run it) with the Host Agent Disabled and then reun the Host Agent again.
On first part of the image as you can see host entry has explanation mark which is the Windows 2008 R2 hosts. Whats odd since installing Host Agent and PP software all the Initiators entries has disappeared. I can confirm these initiators were there before these software was installed. Second screen shot shows PP within Windows OS again I can see the storage but some reason I cannot understand why its not displaying second HBA. If you can put me in right direction I would be greatful. This server is standalone box and not part of Microsoft Clustering. Before I go down the route unzoning and rezoning back again want to make sure I am not going down the wrong path.
dynamox
11 Legend
•
20419 Posts
•
87439 Points
2106
0
Posted March 23rd, 2012 18:00
EMC Host Connectivity Guide for Windows -- A47