I have a dell dimension 4600 2 40gb's a Western Digital and a Samsung, both 7200rpm i believe. I want to know if i can even set up RAID 0 on this computer, if so how do i got about doing this.
Im going to Reformat Both HDD's within the week, and i want to do it then, if i can of course.
You cannot do hardware RAID on this system without adding a PCI RAID controller; there's no RAID controller onboard.
If you decide to go this route, be sure you understand the very significant downsides to RAID 0 - the risk of data loss doubles (lose either drive, lose everything) and if one drive fails or the array becomes otherwise corrupted, it's exceedingly difficult to recover data from a RAID 0 array.
In the Device Manager under SCSI and Raid Controller theres a SCSI/Raid Host Controller, it even gives me the properties, it also gives me driver details as well.
Well i don't think im gonna run RAID 0, mainly for the fact that even if i did buy the RAID Controller, my IDE cable arent nearly long enough to reach the HDD's anyway, so i'll just stick with the configuration that i have right now.
So, what that article says even if i did put them in RAID 0, i would barely even notice the speed increase.
ejn63
11 Legend
•
87469 Posts
•
321256 Points
172
0
Posted November 26th, 2005 22:00
If you decide to go this route, be sure you understand the very significant downsides to RAID 0 - the risk of data loss doubles (lose either drive, lose everything) and if one drive fails or the array becomes otherwise corrupted, it's exceedingly difficult to recover data from a RAID 0 array.