UNSOLVED

tskey

updated

18 years ago

T

tskey

1 Message

0

5826

June 13th, 2008 18:00

PE2800 Raid recovery

The motherboard on my 2800 blew up and was replaced.  The original configuration for the disks was a RAID 5 with a hot spare.  The new motherboard does not know of this configuration.  I need to retrieve the configuration file from the drives to tell the new perc controller how they are configured.  Does anyone know how to do this?
  • PsychoT

    62 Posts

    226

    0

    Posted June 13th, 2008 19:00

    What PERC are you using and what firmware is it at?  Also, what are the scsi ID's of your drives and your Hotspare.
  • snapohead

    1230 Posts

    226

    0

    Posted June 16th, 2008 04:00

    SCSI ID's are irrelevant, as is the firmware the PERC is using.

    Firstly, was the ROMB key transferred across when the MB was swapped?

    If not, you're in trouble.

    If it was, check the BIOS under "Integrated Devices", and ensure that RAID is enabled (as apposed to SCSI) on the Embedded SCSI controller.

     

  • PsychoT

    62 Posts

    226

    0

    Posted July 4th, 2008 02:00

    I hate to say it... but the PERC, ID's and firmware revisions are very much relevent...  Also, you're assuming he's using the ROMB (hence why I asked what PERC it was).  And if it is the ROMB, swapping only the raid key over is simply not enough.
  • pcmeiners

    6 Operator

    •

    1771 Posts

    226

    0

    Posted July 4th, 2008 11:00

    In the meanwhile, Tskey...

     

    As the drives are SCSI, I hope you do not mix up the drive order, mark the drives before you pull them, know which drives go to which raid channel, if more then one . In SCSI, with the newer raid interfaces, drives can be of a different order on a per channel basis (drive roaming), but drives placed on a channel can not be moved to a different channel; channel roaming is not permitted. So any drive on say channel 0, must be placed onto the channel 0 of the new raid interface. Adhered to this restriction, if your moving the drives to a new controller which is the same or an upgrade which will accept drives from the defunct controller, the new adapter should read the COD (configuration on disk) and startup. You may need to clear any configuration on the new adapter before the COD is accepted. If you place drives on the incorrect channels you have a good possibility of losing the array, the array definitely will not start.