
UNSOLVED
CK
Chris Knight
14 Posts
0
8964
March 16th, 2010 17:00
PE 4300 Hot Swap
So I've been refurbishing a PE4300 that I bought at a YMCA Thrift Shop so I don't have any software for it. Through trying different setups I have come down to a question about Hot Swapping the hard drives. I installed 6 identical IBM 36gb HHDs. The server came with a 8540V PERC 2/SC card. I installed Windows 2000 Server on Drive 0 and Drive 1 will be used for a website (if I ever set it up) leaving the other 4 Drives (2-5) for storage. The system ran fine and I could see all of the drives including a CD-Rom on the 50pin on board channel and a CD-RW & 250 Zip drive connected through an Ultra 66 IDE Card.
Today I switched the backplane connection to the PERC 2/SC card. I setup Drive 0 as A0-0 and Drive 1 as A1-0. I left Drives 2-5 as Available on Ready. The system boots up to OS fine and in my computer all of the drives show up like normal except 2-5 which I am assuming is because I have not put them in a RAID array. So at this point I think I've done everything right.
Now the reason I'm even using the PERC 2/SC is because I've heard about the Hot-Swap cability. From what I've read I need a RAID controller because it only applies to RAID arrays. What I would like to do is run all of the drives as singles drives due to the limiting 36gb capacity (tried 73.6gb drives and it didn't work).
Could I set up each of the drives in an individual array and just swap the hard drives in an out?
Would the swapped HDD need to be the same size since the array would be a single drive? I have several 18gb drives it came with is why I ask that.
What software would I need in the OS for hot swapping? I don't have any of the software the system came with.
Thanks!
Responses (0)
Solutions (0)
