You need to clear the foreign config on the drive to use the drive to create a new VD. You will loose all the data on the drive when you do this. You can refer section "Importing Or Clearing Foreign Configurations Using The VD Mgmt Menu" on page 45 of below link for steps to clear the foreign config.
Initially thank you very much for your attention, could you take another question? when I look at IDRAC it shows "Virtual Disk 0" when I put disk 4, but that and the name of my Virtual Disk 0 is configured for Disks 0,1,2 and 3 (currently raid 10)
Doing this cleaning of disc 4, do I risk losing the data on the other disks?
Complementing the previous question, I need to know if there is any risk of loosing data on my existing Virtual Disk when i execute the procedure of Clearing the disk with the foreign configuration.
I currently have four SAS disks (0, 1, 2 and 3) configured in RAID10, resulting in a Virtual Disk of 600Gb.
Then I added two SAS disk (4 and 5) and I will configure them in RAID 1, resulting in a new Virtual Disk of 300Gb.
The disk 4 is the one showing the foreign configuration.
I followed the orientations of the section "Importing Or Clearing Foreign Configurations Using The VD Mgmt Menu", page 45 of the User´s Guide refered above, as shows the attached picture, but I still am afraid of pushing the Clear button and loose data on my main VD of 600Gb. Is there this risk?
From the screenshot it looks like the foreign drive inserted was also part of another virtual disk of RAID 10. It is also looks like virtual disk to which foreign drive was part of is also name as "Virtual Disk0" which is creating confusion. You can rename your current virtual disk to remove this confusion. Please ensure you current virtual disk is not shown as degraded or failed before trying importing or clearing the foreign drive.
You can also insert the disk to another server clear the foreign config and insert the drive back to this server. Another option is instead of clearing foreign config you can import the config which will show one for virtual disk in failed state and later you can delete the second virtual disk. clearing the foreign config should not impact current virtual disk you have. It will clear the configs which is available on drives shown as Foreign.
DELL-Shine K
6 Operator
•
3042 Posts
441
1
Posted November 26th, 2020 06:00
You need to clear the foreign config on the drive to use the drive to create a new VD. You will loose all the data on the drive when you do this. You can refer section "Importing Or Clearing Foreign Configurations Using The VD Mgmt Menu" on page 45 of below link for steps to clear the foreign config.
https://downloads.dell.com/manuals/common/rc_h310_h710_h710p_h810_ug_en-us.pdf