Optiplex 7090 USFF cpu upgrade from i5 10th gen to i9 11th gen running slow.
Hi - just looking for some clarity. As above ive just upgraded the cpu from an i5 10th gen to an i9 11 gen....pc is running slowly - im running proxmox on it. CPU speeds are showing 800mhz but ive ran some unlocking tools which have worked. Im looking online and just found that there is a 130w 4.5mm tipped psu (ive currently got a 90W) - is this right? that the 130w supply will make the cpu work at the correct speed at hardware level/powerup?
A higher wattage power adapter should help, but an i9 CPU isn't well suited to a small form factor system due to the heat it generates -- it is very likely to throttle under moderate or higher workloads.
There's not much you can do to improve cooling on a small form factor system.
That's exactly why you do need to worry about cooling. All modern CPUs have thermal limits and will throttle performance if the temperature rises too high.
Many tried fitting i9 CPUs in notebooks and gave up because they actually perform worse than their i7 counterparts due to the added heat load. Though you have a desktop system, it is small in size meaning the heatsink and fans are limited in cooling capacity. I suspect what you're seeing is thermal throttling.
And pushing up the clock speeds by utility will only make that problem more and more evident.
Yes, it's counterintuitive, but the faster the CPU runs, the more the cooling deficit of the small form factor becomes an issue.
@ejn63 Im aware of cooling....been messing around with computers for 40 years....i did pre check the cpu config was compatible - the i9 11900 is a known upgrade for the usff design. All i want to do is make sure the 130w adapter will run it at the correct speed - this is not the K variant. The 11900 is a Dell certified upgrade.
I doubt it. Both CPUs have the same 65W total design power. It may be the i9 draws more power on average than an i5 but the total design power is the same.
As I mentioned, there are plenty of buyers of Mac, Dell and other notebook computer who came to realize that i9 CPUs were real-world slower than i7s of the same generation due to thermal throttling.
If you still have the original CPU and it runs at full speed, while the i9 replacement does not -- that is almost certainly the issue. The i9 CPUs bring bragging rights -- not real world performance benefits.
Yes, that 800 MHz floor is exactly what you get when the machine thinks it is on an undersized adapter, so the 130W question is worth chasing before anything else. In the BIOS setup screen, check what wattage it actually reports for the adapter — if it says 90W or unknown, that cap is coming from the adapter ID, not the CPU itself. If a genuine 130W 4.5mm unit still shows up correctly there and the speed still sticks at 800 MHz under load, then look at the power and thermal limits in BIOS rather than forcing clocks higher, since those unlocking tools can hide the real limit. Also worth a quick check in Proxmox that it is not just reporting the idle speed — put a proper load on a couple of cores and watch what the frequency does then, as idle 800 MHz on its own is not always a fault. That should tell you whether the adapter swap actually fixed it or whether you are still hitting a firmware power cap.
@noahmitchell Thanks very much for the info. I did have a 130w dell usb charger which i bought a conversion adapter for. But it didnt change. I will get one of the official 130w adapters though. Great help thanks. Ill post back when the new adapter turns up.
Comfy
1 Rookie
•
111 Posts
•
55 Points
11
0
Posted October 27th, 2026 16:46
130w PSU turned up today. Its now working correctly. No need to run the command to open up the clocks. So thats the answer.