ashxos

updated

18 years ago

A

ashxos

142 Posts

0

1304

January 6th, 2009 05:00

Frequent change in the SCSI Address of Quantum Scalar i500 Library

Dear All,

I am facing Library related issue.

When I am restarting my Backup Server, sometimes Networker is changing the SCSI address of our library from one to another(Quantum Scalar i500)

e.g.
scsidev@2.1.1:ADIC Scalar i500 420G|Autochanger (Jukebox)
-----to-----
scsidev@2.2.1:ADIC Scalar i500 420G|Autochanger (Jukebox)

Resulting, I need to configure the Library once again, and Inventory also, which is taking the HELL of Time.

Is their any solution to prevent the SCSI Address change, or any another solution is their from Networker itseft.


NetWorker version nw_7_3_2_jumbo.Build.386

OS: Windows Server 2003 Std Edition 32 Bit SP2


Thanks in advance!
.::[ashX]::.
  • Hari5

    443 Posts

    783

    0

    Posted January 7th, 2009 16:00

    Well ... with Qlogic HBAs, you would need to use sansurfer to the persistant binding and ensure that all the drives are bound to specific targets. Yes, you would need to make sure of the drivers as well.

    I have never had a problem where the targets have changed provided the persistant binding is properly applied. Of course, if you change one of the tape drives it self, you would need to do the binding all over again.

    Software for persistant binding would depend on wether you are using Qlogic HBAs, Emulex HBAs or SCSI connected devices. Use sansurfer for Qlogic, HBAnywhere for Emulex and you would need to change some registry keys if SCSI connected rather than SAN.
  • HabibG2

    455 Posts

    783

    1

    Posted January 6th, 2009 06:00

    Yes, you have to consider applying Persistant Binding.
  • Hari5

    443 Posts

    783

    0

    Posted January 6th, 2009 15:00

    Unless you apply persistant binding both for your library and for the tape drives in it, you will face this problem with both the library and the tape drives.
  • DeaconZ28-2015

    1 Rookie

    •

    252 Posts

    783

    0

    Posted January 7th, 2009 10:00

    That doesn't always work.

    Make sure your Qlogic drivers are up to date as well as getting the tape device drivers from IBM (make sure you disable the Control port failover with the disableCPF.reg file).

    Mine occasionally switch names in Windows e.g. \\.\Tape0 becomes \\.\Tape7 and vice versa. Even though the scsi address appears to stay the same. Its extremely frustrating when you have to delete/readd/reconfigure your jukeboxes.

    But at least with 7.4.3 it takes little time to re-inventory compared with older versions.