Airborne just delivered my fixed 2007WFP so Dell is starting to get them in the distribution channels. This monitor was shipped from Austin, TX.
The revision I received is "A01 Made In Mexico" and is stamped "AUDITED" on the outside of the box.
The desktop mode is showing VERY little banding when I run a few of the monitor tests. I get similar results on my two laptops and my old 2001FP so the repair is acceptable (for me anyways) in the desktop mode... The other two modes are the same as the un-audited monitors. This revision is still using the LM201W01 panel.
However, when running the gradlin gradient test that people have linked to here I can't see any banding in VGA mode. When I run it in DVI mode I can see the banding people are talking about - but in other normal operations, I did quick five minute tests, playing COD2, image viewing and editing, watching DVDs, all in desktop mode with both DVI and VGA - I couldn't see any banding [in all honesty I could see any difference in image quality]. . . I ran out of time before I had to leave for work this afternoon [Thanks Fedex! LOL] but at least I got the monitor, its up and running and so far so good. But, thats not to say that in DVI mode that every day to day normal operation will be exceptable - I still have to observe the panels performance on some of the other tests and websites many others have linked here. . . I'll be looking at them all with this in mind - Is this exceptable for me? I am going to say upfront that I think it will be - So far this monitor is better than my sony 17" LCD and it blows the socks off my old generic 19" CRT.
More tests and extended tests will be conducted - and I'll report back - although it seems that this point is nearly moot as the revision A01's are beginning to hit the market. . . I noticed the price went back up to $450 yesterday - so that makes sense.
I will say this it took a while for me to find in my 6800GT control panel where I could bump up the resolution to 1680x1050 [in windows properties > settings the highest resolution was 1600x1280 it think] - at resolutions below 1024x768 Banding was horrible. But now that I have it set on 1680x1050 the image quality is acceptable.
Not to belittle any of the others who have worked so hard testing and speaking with Dell to work on a solution - my hats off to you - and I'll most likely take advantage of all that hard work so thanks!
I'll work on getting images and everything else done this evening after work. . .
darrenke
5 Posts
178
0
Posted June 5th, 2006 16:00
see this thread:
http://forums.us.dell.com/supportforums/board/message?board.id=dim_monitor&message.id=57388