
UNSOLVED
W
wendellscout
2 Posts
0
33698
March 24th, 2015 17:00
Precision T3500 won't boot known good windows hard drive
Hello, I have a Precision T3500 that will not boot a known good WIN7 drive. I actually have two of these desktops, and have used the working one to verify that the hard drive is not the issue. I also cannot boot to a bootable usb drive to even get to the preinstallation environment. This unit is out of warranty, I'm wondering if anyone has ideas......motherboard? It also has a second hard drive slot and I have attempted to boot from the second slot (Disk 1 vs. Disk 0) with no luck. Diagnostics freeze during the extended test. Any thoughts would be appreciated. Thanks very much.
Responses (4)
Solutions (0)
wendellscout
2 Posts
1350
0
Posted March 25th, 2015 06:00
I'm sorry for the lack of clarity in my post, I hope this helps:
1. RAID is not set up, I just went into Setup, unchecked Disk 0, and checked Disk 1/rebooted so that I could verify that the Disk 0 connection to the motherboard wasn't bad. I have since changed it back to the original configuration where Disk 0 is checked, Disk 1 is unchecked and (unchanged) Disk 2 is the CD/DVD drive.
2. The power button stays green, and no diagnostic LEDs are on when it hangs trying to load windows or when trying to do a startup repair. If any code was being displayed it would be after the initial boot, correct? I attempted to re-run diagnostics this morning, and currently it is hanging at the "WCMch Test".
3. There are no beeps from the tower during boot or otherwise.
4. This drive has Windows 7 Enterprise 32-bit installed. I actually just reimaged it to be safe, and as I mentioned it boots normally in my other working T3500. But when I put it back in this one, it freezes when loading windows. The same thing happens when I take the drive from the working T3500 and put it in this one. Very strange.
Thanks for your help and input, please let me know if you need any more details.
It's failing WCMch Test which is a memory test. So first thing would be just to reseat the modules in their slots.
If that doesn't work, remove all modules except from slot 1 (check manual for location) and see if it boots. Then swap all of them one at a time into slot 1 to see if you can ID a bum module. If they all work in slot 1, add a module to slot 2, etc. until you ID a bum slot or all are successfully reinstalled.
If you decide just to swap them with the other system as Tzarder suggested, be careful not to mix up the modules from the 2 systems. They may not all have identical specs (especially if different brands) and mis-matched pairs can cause grief. So keep them separate.
If you find one bad module, you'll have to replace it as a matched pair of new, identical modules.

RoHe
12 Elder
•
45230 Posts
•
172625 Points
1350
0
Posted March 24th, 2015 20:00
Is this a RAID setup with the 2 hard drives? If yes, is it RAID 0 or RAID 1?
What color is the power button and are any of the diagnostic LEDs on? See page 7 in the manual for error codes.
Any beeps from the tower?
What version of Windows?