
UNSOLVED
ST
Serious Tom
17 Posts
0
8506
November 7th, 2006 17:00
Power Supply
I'm a little confused. I have a old Dimension 8200 and everyone says that Dells power supply's are propiatory. But if you look at the pin outs in the on line manuals here, they appear to be standard ATX and then when I was looking at adapters for the Dell power supplies here http://www.endpcnoise.com/cgi-bin/e/std/sku=dellconverter they say at the bottom of the page :
Known exceptions:
Pentium 4 Dell Models that do not require a power supply adapter:
Dell Dimension 4300, 4400, 4700, 8200, 8300, OptiPlex GX 400
Does ALL this mean I can use a Standard ATX Power Supply ?
Known exceptions:
Pentium 4 Dell Models that do not require a power supply adapter:
Dell Dimension 4300, 4400, 4700, 8200, 8300, OptiPlex GX 400
Does ALL this mean I can use a Standard ATX Power Supply ?
Responses (4)
Solutions (0)
shesagordie
12 Elder
•
46017 Posts
291
0
Posted November 7th, 2006 18:00
Serious TomHappy to hear everything worked out and that you saved money. :)Bev.Please don't send me questions about your system by DCF Messenger.
Post the issue in the appropriate Board, where they will be answered.Serious Tom
17 Posts
291
0
Posted November 7th, 2006 18:00
Thanks, I had an old 430W Antec and just now hooked it up. It powered on fine except some Dell screen popped up saying to run some utility because the configuration had changed. I had all my pci cards pulled out. I'll put them back in and modify the back of the 8200 a small bit to except a on/off switch. Thanks a lot, you'se guys saved me some dough and cleared up my confusion to boot.

shesagordie
12 Elder
•
46017 Posts
291
0
Posted November 7th, 2006 17:00
The PSU's in the Dimension systems, prior to these systems are not standard and are proprietary.
There are some models, where a power supply with the on/off switch can be used without having to modify the back panel
The Dimension 4700, 8400 systems and above, use the newer standard ATX [24-pin motherboard power connector] power supplies.
Bev.
Post the issue in the appropriate Board, where they will be answered.