UNSOLVED

White_Tiger

updated

20 years ago

W

White_Tiger

22 Posts

0

47319

March 19th, 2007 23:00

E510 Won't Boot with Eithernet cable plugged in or will shut down if I plug it in??????

At first the E510 was shutting down by itself and it would power back up sometimes when I pushed the power on button.

It was then not powering up at all, or would start to power up and in 2-3 seconds power down and try to reboot again. This would repeat over and over 8+ times and then stop with no boot up.

If I held the power button in it would start to power up (dell message on computer screen) and then power down within 5-7 seconds.

This would happen even with the computer idle for hours or if I unplugged it and drained residual power by holding the power button in with the computer unplugged.

I took the panel off the side looked around and decided to try disconnecting cables at the back of the computer.

First I unplugged the Printer cable - same issue.

Then I unplugged the Ethernet cable and it booted right up. With the computer booted up I plugged the Ethernet cable back in and it powered down. I then unplugged the Ethernet cable and the computer powered back up.

I then went and purchased a new Ethernet cable and plugged in one end into the computer and did NOT plug the other end in – It booted right up. As soon as I plugged in the other end into the DSL box (ActionTec) the computer powered down and would not power back up until I unplugged the Ethernet cable from either end would work.

Thoughts, help or ideas outside of Gnomes or Gremlins since I have fumigated for them.

E510 is out of warranty of course :-) 

 
  • PETER345

    1 Rookie

    •

    5796 Posts

    1520

    0

    Posted March 20th, 2007 15:00

    It sounds like like there is something wrong with the DSL modem (box). Possibly the Ethernet connector is damaged or you have a grounding problem. Do the link lights come on DSL modem and the PC? It is also possible the problem is at the connector on your machine.

    If you have a switch or hub or another DSL modem, try going through those rather than connecting directly to the modem. Can you connect to the modem with other machines?

    You can also try buying a cheap Ethernet card (if you don't have another machine) and trying that. Fry's has them for $.99 periodically.

    Peter
  • White_Tiger

    22 Posts

    1520

    0

    Posted March 20th, 2007 15:00

    Greetings Peter,
    My Netgear box that is plugged into the DSL works for my laptop and is not effected when I plug the PC into either Netgear or DSL box, and I tried plugging into it as well with the same result with the PC powering down. Also I have tried different plug ins on the DSL with the same result.
     
    Could it be a software issue or some log etc that I can look for to see if there is a power off command when connected to the internet? I have run P-cillen and no viruses detected.
     
    Any help will be very much appreciated.
     
     
  • PETER345

    1 Rookie

    •

    5796 Posts

    1520

    0

    Posted March 20th, 2007 15:00

    I don't think this software. Anything that prevent your computer from powering up sounds like hardware to me. I've never heard of anything like "power off when you connect the network". That would be pretty ridiculous.

    When it powers off, does it do so in an orderly (i.e. Windows is shutting down ...) or abrupt (i.e. power goes off instantly) fashion?

    Peter
  • PETER345

    1 Rookie

    •

    5796 Posts

    1522

    0

    Posted March 20th, 2007 15:00

    In that case, you could try reinstalling the NIC drivers.

    However, none of that explains how it could prevent the machine from powering up.

    Is there anything in the event log? I suspect a power down event like that should be logged.

    Peter
  • White_Tiger

    22 Posts

    1522

    0

    Posted March 20th, 2007 15:00

    Orderly Windows shutting down manner with message and all.
     
     
  • White_Tiger

    22 Posts

    1522

    0

    Posted March 20th, 2007 16:00

    In the "Event Viewer" Systems the only "error" that I see is one that states: "The Bonjour Service hung on starting.
     
    Anything else I should be looking for?
     
    Thanks again.
  • PETER345

    1 Rookie

    •

    5796 Posts

    1522

    0

    Posted March 20th, 2007 17:00

    Those are the drivers for the Ethernet card. You can check support.dell.com for updated drivers.

    Peter
  • PETER345

    1 Rookie

    •

    5796 Posts

    1522

    0

    Posted March 20th, 2007 17:00

    I would look at the time when it shuts down and see what is logged.

    Peter
  • White_Tiger

    22 Posts

    1522

    0

    Posted March 20th, 2007 17:00

    The Bonjour Service note is the only error message that shows up at the time of power down.
     
    What are the NIC drivers and how do I reinstall them?

  • PETER345

    1 Rookie

    •

    5796 Posts

    277

    0

    Posted March 20th, 2007 18:00

    Are you using Vista? If so, maybe you have hit a Vista or driver bug.

    The XP driver is here:

    http://support.dell.com/support/downloads/download.aspx?c=us&cs=04&l=en&s=bsd&releaseid=R105827&SystemID=DIMENSION%205150/E510&servicetag=&os=WW1&osl=en&deviceid=4030&devlib=0&typecnt=0&vercnt=1&catid=-1&impid=-1&formatcnt=1&libid=5&fileid=136683

    Peter