
UNSOLVED
BIOS / MOTHERBOARD ???
Hi Everyone Out There:
I have a Dimension 8300, running Windows XP Pro.
Every time I reboot or boot up; my system freezes at the Dell Logo Sign. After about a minute; I get a notice of Keyboard Failure; or the Hard Disk is not reconized; and that I should press F2 to get into the BIOS. When I get into the System BIOS Boot Section; there are the usual three options, Boot from the IDE Rom, Hard Drive, or the Floppy Drive. I then have to go to the Hard Drive and highlight it. Then I press escape twice, then the system would boot up properly. However; sometimes I cannot do anything concerning using the keyboard; I then have to do the above again before I can start typing; just like I am doing now.
Could anyone out there help me get over this problem.
Thank you,
Allan
Responses (31)
Solutions (0)
Karts4Kids
99 Posts
413
0
Posted November 12th, 2006 12:00
If it is the battery there will be a log in system setup. Were there are logs?- Allan, once the battery is replaced, if you still experience problems then check the diagnostic lights when this happens. The lights could give an indication of an error code which will help in pin pointing the problem. I would tell you to do this now, but a failing battery can produce erroneous error codes so it is best to rule out the battery first. You can click here for an explanation of those error codes from your model's on-line Service Manual if need be.
- Allan, since you are encountering a variety of boot up problems related to hardware detection I would suggest replacing the motherboard battery. A failing battery can cause these types of problems. A new 3-Volt, CR2032, coin cell battery can be purchased for around $3 (US) and is available at any Radio Shack, computer stores and most discount stores like Wal-Mart. You can click here for information on how to change the battery from your model's on-line Service Manual. While the battery is removed I would suggest clearing the NVRAM using the procedure I have listed below......With the machine unplugged from the wall remove the battery from the motherboard. Then with the machine still unplugged press the On button for 15 seconds to dissipate any remaining electrical charge on the motherboard. Then re-install the battery, plug the machine back into the wall and see if it will boot normally.
Message Edited by Majestic on 11-12-200608:12 AM
- Hi Again; I am not an advanced person as far as computers are concerned. However; I do not mind getting to grips with anything to do with the computer. Normally, where is the battery located on the motherboard, and what shape is it?Thanks,Allan
Karts4Kids
99 Posts
413
0
Posted November 12th, 2006 13:00
It looks like a big old watch battery. Can't miss it......you may need something to carefully assist prying it out of the socket.- I have done this some many times already. It does not work. However, I thought of something. Before everything used to work like clockwork automatically. Now I manually have to get my system working through the BIOS. Does this tell you anything?Allan
Karts4Kids
99 Posts
372
0
Posted November 12th, 2006 14:00
According to your manual it means the following: A possible floppy or hard drive failure has occurred. Reseat all power and data cables and restart the computer.

Karts4Kids
99 Posts
413
0
Posted November 12th, 2006 03:00