
UNSOLVED
B
berryhedgehog
21 Posts
0
93935
December 21st, 2014 11:00
Installing Corsair cooler on Aurora R4; can't control the fans
Aurora R4, Windows 8.1, everything is updated to the latest versions
My stock pump failed. First I tried air cooling (Cooler Master 212 Evo), and it didn't fit by approx. half a centimeter due to the component sticking out above the CPU.
Then, I bought the Corsair H80i system, which was highly recommended on these forums. It comes with a USB to the motherboard. The device manager would only show it as an "unrecognized device" and couldn't find drivers. I tried all the ports on the motherboard and a cable to the back as well; it didn't work. It ran, but I couldn't control the fans: they just ran max speed the whole time.
The store associate told me to try exchanging for a Corsair H75, which is about the same but no USB cord. I also can't control the fans on this, either through Command Center or through various versions of Corsair Link. Corsair Link does show the fans running max speed but can't change them. Command Center shows the wrong number entirely. I uninstalled Corsair Link, and that didn't help. I know that you need the 7pin adapter to show the pump properly, but the fans should be showing up fine, right? They are 4 pin fans with a Y-cable joining them. I have them plugged into SYS_FAN and the pump itself plugged into CPU_FAN. I haven't seen a single BIOS error the whole time. Also, the Y-cable looks like it's missing a pin; I don't know if that might be affecting it, but I think the H80i cord was fine and it still didn't run.
Responses (0)
Solutions (0)
