JFH2

updated

2 years ago

J

JFH2

1 Rookie

•

33 Posts

•

2 Points

5

2509

May 9th, 2024 16:15

G15 5515 Screen Black after BIOS Updated to 1.18

Updated the BIOS for my G15 5515 from 1.16 to 1.18 today and immediately after the update the screen went black and won't turn on. The laptop works and I can use an external monitor but still can't believe that Dell pushed a BIOS update that bricked my screen. Seems to be a common occurance. I have tried to boot into BIOS Recovery mode but am not having any luck. Any other suggestions?

  • DELL-Nat M

    Community Manager

    •

    3803 Posts

    •

    21463 Points

    0

    0

    Posted May 24th, 2024 13:15

    (marking as solution for visibility only)

    Hi everyone,

    The bridge BIOS is now available for installation. If you need to downgrade to a previous version, please follow these steps:

    1. Contact tech support via the "Get Help Now" chat (button located at the bottom right corner of the page).
    2. The agents will guide you through steps to reset the RTC.
    3. If the RTC reset doesn't resolve the issue, the agents will escalate your case to get the bridge BIOS.

    Important: Please note that the agents must follow a specific process, so even if you've already tried the RTC reset, they will need to verify it again. Your cooperation is appreciated.

    Thank you for your patience and understanding.

    (edited)

    #IWork4Dell

  • Ahmadmowafk

    1 Rookie

    •

    2 Posts

    •

    2 Points

    0

    0

    Posted May 10th, 2024 13:25

    I have the same problem, did you solve it? 

  • JFH2

    1 Rookie

    •

    33 Posts

    •

    2 Points

    0

    0

    Posted May 10th, 2024 14:04

    @Ahmadmowafk​ I have not solved the problem. If you look on Reddit (search for the thread "BIOS broke my laptop" as well as "Updated Dell G15 5515 Ryzen, now only screen black" and you will see that this is a common occurance with this laptop and any BIOS updates. However, after contacting Dell Support, they continue to say that the issue is not with their BIOS updates, even after I point them to all the threads on here as well as Reddit.

    My one suggestion would be to create a support ticket with Dell so that this can get on their radar. It seems like it will only be fixed once enough people complain.

  • Ahmadmowafk

    1 Rookie

    •

    2 Posts

    •

    2 Points

    0

    0

    Posted May 11th, 2024 12:30

    @JFH2​ no contact yet ? I tried a lot🤦🏻‍♂️

  • JFH2

    1 Rookie

    •

    33 Posts

    •

    2 Points

    0

    0

    Posted May 11th, 2024 18:05

    @Ahmadmowafk​ Still no updates from Dell. 

  • Ahmad Mowafk

    1 Rookie

    •

    15 Posts

    •

    2 Points

    0

    0

    Posted May 12th, 2024 11:10

    @JFH2​ please reply here if you got any solution 

  • mbneto

    1 Rookie

    •

    9 Posts

    •

    2 Points

    0

    1

    Posted May 12th, 2024 11:14

    Same laptop, same problem: my display was gone as soon as the BIOS update from 1.16 to 1.18 was complete. LED is blinking 2 amber 7 white, SupportAssist shows PCI failure and Video failure.

    I can only use the laptop plugged on an external display and cannot access BIOS settings or BIOS recovery since those only display on the laptop screen (which is now dead).

  • JFH2

    1 Rookie

    •

    33 Posts

    •

    2 Points

    0

    0

    Posted May 12th, 2024 22:11

    @mbneto​ exactly the same thing that happened to me. Have you reached out to Dell support? Still can't believe that they tried to tell me the issue wasn't caused by the BIOS update. 

  • mbneto

    1 Rookie

    •

    9 Posts

    •

    2 Points

    0

    0

    Posted May 13th, 2024 01:13

    @JFH2​ since my warranty has long expired, I need to wait until Monday before being able to contact support during business hours. I'm not holding my breath for the phone support rep to be helpful. Meanwhile, here are some things I tried, none of which worked:

    • Tried going back to firmware 1.16.0 using the installer:
      • It says I'm not allowed to downgrade and won't do anything.
    • Tried to clear the BIOS settings/RTC to factory defaults by unplugging the battery, then holding the power button down for 60 seconds: 
      • Settings seem to have been cleared (clock was reset, and I had to fumble with the keyboard to get it to proceed into Windows), but display is still dead.
    • Tried to clear the BIOS settings/RTC to factory defaults by turning the laptop off and then holding power for 30 seconds until the power LED blinked three times:
      • Same result as the battery unplug method.
    • Tried entering BIOS recovery by all different methods I found online (plug AC while holding down CTRL+ESC or FN+CTRL+ESC, or tap the power button while holding the same keys), but in all attempts either nothing happened or the PC just booted into Windows as usual:
      • Just plugging the AC does nothing, no matter which keys I held or for how long.
      • Tapping the power button while holding the keys just proceeds into Windows.
    • Tried running the 1.18.0 installer again:
      • The install seems to have gone normally (PC rebooted, fans went into max speed for a minute or so, then rebooted into windows), but the display and was off and the power LED was blinking 2-7 during the entire process, until I was back to Windows on my external display.

    BTW, if I go into device manager the AMD Radeon(TM Graphics) device has a warning sign, stating something along the lines of "Windows has stopped this device because it has reported problems. Code 43".

    I suspect the BIOS update did something to the AMD iGPU either at the firmware level or UEFI level that broke compatibility.

    (edited)

  • JFH2

    1 Rookie

    •

    33 Posts

    •

    2 Points

    0

    0

    Posted May 13th, 2024 03:34

    @mbneto​ I have done the exact same things as you with the exact same results. I had to laugh when Dell support just told me to downgrade to 1.16 but when I try, I get the same message that it is not allowed to revert back to previous BIOS version. 

    Please let me know if you have any luck with Dell Support on Monday. Interested to see what they say to you since now this is clearly not a one off issue. It is obviously happening to several users.