If you SSH into the CMC, you can then do a "connect switch-1" to get into the serial connection of the switch. Assuming you didn't set security up to force logging in via serial too, you can change the password from the serial prompt.
The other option is via the CMC's switch fabric option (where you can also set the IP address).
Dev Mgr
6 Operator
•
9308 Posts
•
3 Points
6451
0
Posted January 23rd, 2018 18:00
If you SSH into the CMC, you can then do a "connect switch-1" to get into the serial connection of the switch. Assuming you didn't set security up to force logging in via serial too, you can change the password from the serial prompt.
The other option is via the CMC's switch fabric option (where you can also set the IP address).