MickWindows

updated

5 years ago

M

MickWindows

1 Rookie

•

18 Posts

0

4376

August 2nd, 2021 02:00

Dell silently updated SupportAssist to v3.10.0: It no longer works at all

Because of my BIOS update issues, I ran SupportAssist. It stalls for about 4 minutes, then gives the following error:

 

"We ran into an unexpected issue with SupportAssist. Restart your PC and try again later"

Existing version is 3.10.0 (2021)

Running Dell Command | Update (v4.2.1) reports that there are no updates for my system (XPS 13 9370).

  • MickWindows

    1 Rookie

    •

    18 Posts

    3252

    0

    Posted August 9th, 2021 04:00

    Hello community helpers, I have quite a tale to tell. Dell support determined that my XPS 13 motherboard required replacement. A service rep promptly replaced it within 2 days. The BIOS initially refused to update from 1.11.1 to 1.15.0, from either the BIOS or the desktop. I re-ran from the desktop and the BIOS did update. Later I discovered that the right-side USB port no longer worked (meaning unbootable via USB). Dell spent several hours online and determined that the new motherboard was also defective. Today a 2nd Dell tech replaced the motherboard. This time we jointly checked the BIOS update (OK) as well as all 3 Thunderbolt/USB ports. I restored a backup from before the 1st replacement, and all is well again.

  • jalopeno

    1 Rookie

    •

    44 Posts

    1465

    0

    Posted May 6th, 2022 12:00

    If the BIOS update being installed via Support Assist is bricking computers, Dell should remove it from the Support Assist installation options until they have a fix. It's ridiculous that updating drivers to fix a USB or audio issue or something might also break the computer if the admin/whoever hadn't come across this thread and knew to not check the BIOS update checkbox. Ugh.

  • MickWindows

    1 Rookie

    •

    18 Posts

    3199

    0

    Posted August 2nd, 2021 03:00

    Solution: uninstall all 3 SupportAssist programs from Windows 10. Go to Dell Update; re-install the NEW version of SupportAssist (3.10.1).

     

    Dell, this shouldn't be necessary.

  • fireberd

    11 Legend

    •

    33399 Posts

    •

    112848 Points

    3354

    2

    Posted August 2nd, 2021 05:00

    DO NOT do a BIOS update via Support Assist.  We have seen a lot of BIOS update issues (including bricked PC's) with SA.  Only update BIOS, if needed, with manual download and install.

     

    Inspiron 16 5630 Laptop and WD22TB4 Docking Station
    Self-built desktop for recording studio application
  • Mary G

    6 Operator

    •

    20095 Posts

    3351

    2

    Posted August 2nd, 2021 06:00

    Dell should take bios updates out of Dell Updates as well as Support Assist. It is especially dangerous when there are also other updates reported at the same time. That bricked a user's computer just this weekend.

  • garioch7

    7 Practitioner

    •

    318 Posts

    •

    1621 Points

    3342

    1

    Posted August 2nd, 2021 10:00

    @MickWindows 

    I concur with the advice that you have been given by @fireberd and @Mary G .  I don't have their expertise, but updating a BIOS using Dell Update or SupportAssist particularly, is far too risky for my comfort level.  This topic might be of interest to you.

    Just my two cents.  Have a great day.

    Regards,
    -Phil

  • MickWindows

    1 Rookie

    •

    18 Posts

    3320

    0

    Posted August 2nd, 2021 22:00

    Thank you for your advice - I have learned something important. FYI, I have now tried a direct BIOS update using the EXE file on a FAT32 USB stick. Same problem though - the BIOS runs the EXE and immediately just reboots the XPS into a normal boot. I have fed this info back to Dell.

    Regards, MJS.

  • MickWindows

    1 Rookie

    •

    18 Posts

    3320

    0

    Posted August 2nd, 2021 22:00

    Thanks for this advice, which I shall follow from now on. Sadly, in this case the EXE file still doesn't work from a BIOS->USB drive update. I have notified Dell.

    Regards, MJS.

  • MickWindows

    1 Rookie

    •

    18 Posts

    3320

    0

    Posted August 2nd, 2021 22:00

    Thank you for advising me about this. Much appreciated. MJS.

  • fireberd

    11 Legend

    •

    33399 Posts

    •

    112848 Points

    3306

    1

    Posted August 3rd, 2021 05:00

    The installation instructions state run from Windows.  This is the usual way of updating.

    From the installation instructions:

    Updating the BIOS from Windows

    Note 1: Before updating the BIOS, ensure that you suspend BitLocker encryption on a BitLocker-enabled system. If BitLocker is not enabled on your system, you can ignore this step. For information about how to disable BitLocker, see How to Enable or Disable BitLocker with TPM in Windows at support.dell.com.
    Note 2: Do not turn off power or interrupt the BIOS update process during the update.

    Download and Installation
    1. Click Download File.
    2. Click Save to save the file to your hard drive.
    3. Browse to the location where you downloaded the file.
    4. Double-click the new file.
    The system restarts automatically and updates the BIOS at the system startup screen. After the BIOS update is complete, system restarts again.

     

    Inspiron 16 5630 Laptop and WD22TB4 Docking Station
    Self-built desktop for recording studio application