UNSOLVED

jrfollert

updated

17 years ago

J

jrfollert

1 Message

0

38606

February 15th, 2010 13:00

Replace Raid 5 Drvies with Larger Drives in PE 2950

I have 4 173 GB drives in a raid 5 config, and would like to increase the size of the drives to 300 or more.  Can I just replace the drives one at a time with the larger drives and rebuild or do I have to expand the parttion size after all the drives have been replaced.  Is there a procedure for this.  The unit has a PERC 5/1 controller

  • grm139

    172 Posts

    967

    0

    Posted February 16th, 2010 12:00

    You can replace one drive at a time and wait for the rebuild to complete between replacements.

    You cannot expand the partition to extend the existing RAID 5 over the unused space on the drives, you can create a new RAID 5 volumes on that space or backup you data create, delete the RAID volume, create a new one using all space and restore the data. 

    PERC 5 is unable to expand a RAID volume to use free space on the drives.

  • reybeast1

    347 Posts

    967

    0

    Posted February 16th, 2010 14:00

    GRM139 is correct, can't be done that way. Not sure if you guys have it, but what we do here is use bartpe (with raid drivers) and ghost, and we create a ghost image of the data, delete the virtual disks, create the bigger/new virtual disk, and then put the ghost image back down, works like a champ!

  • atloggia

    13 Posts

    967

    0

    Posted March 11th, 2010 14:00

    Interesting. I've got an old 2650 in which I'd like to do the same thing (replace the old drives with high capacity ones).  I'm going to guess that I can't do that either since my machine is even older (and has a Perc 3/Di).

    So, if I do this and create a new virtual disk, what will I see in Computer Manager under Disk Management? I've got Disk 0 with 3 partitions: the Dell System Utilities, a C (the OS) and a D (data) drive. Will the new virtual disk come up as Disk 1 with unallocated space (until I format it)? Given I'd be going from 33.9 GB drives to 146 GB, I might make the new drive the D drive and take the old D drive and leave it as unused space. Or, maybe I could get tricky and expand the C partiton to use the unused space. Of course, I'll need to find a partition manager and boot from it. Maybe I should just down the Bartpe /ghost route.