After about two months of service, 460 printed pages, 20% spent toner, and 284 ADF scans, 1600n started printing a
vertical black line on ADF copies. I assume there is also a vertical line on outgoing ADF faxes, but haven't tested that. Printing, incoming faxes and flatbed scanning is fine, no lines.
I.e. the vertical line appears on copies of pages that went through ADF (Automatic Document Feeder), but
not flatbed. So assume something's not well with the ADF scanning. Visual inspection and air duster did not improve things.
@mattgorski wrote:
I have this exact problem - has anyone else had and fixed it?
Not me - had to replace the unit under warranty. The online customer service and replacement process is pretty quick and painless, just watch out for the replacement unit's shape: it's going to be a refurb, most likely, and it may not be in great shape. My 1st replacement wasn't, and I sent it back. The 2nd replacement was much better, although still not in as good a shape as my original unit. Oh well. At least it works. :)
I did eventually fix this - egg on my face! It was some piece of blue something stuck on the smaller piece of glass that that ADF uses and the flatbed does not. I had windexed it several times, but the streak was still there. I finally got my flashlight and REALLY looked. I saw the offending speck and scraped it off. It was a very small dot on the glass, but the scanner sure saw it!
Anyway - this one was my fault! But, at least I fixed it myself.
I have experienced the very same problem. And like anothe posted, it is caused, at least in my case, by a very small "something" on the small glass where the document fed from the feeder is scanned.
Lift the feeder, hold down the switch at the rear, slightly to the left, that tells the scanning mechanism if the top ois lifted or down. This will hold the light at the small glass so that you can perform a close inspection.
What ever is there will be small, so take your time and look in the general area wher the black line shows on your scanned document.
Window cleaner and more rubbing wiht a soft non abrasive towel (paper) should clear it up.
mattgorski
2 Posts
300
0
Posted March 4th, 2006 14:00