Precision 3561 (i9-11950H, T600) with TB19S - 4K 30Hz (only)
Hello,
I've read through other discussions on this board and cannot confirm one point:
Has anyone been able to run 4K 60Hz out of the Dell WD19s on *any* of the ports?
The port arrangement from left (edge) to right (edge) on the rear for displays are
[DP] [DP] [HDMI] [USB-C + DP]
It's clear per the documentation that when using *three* displays one must choose HDMI or USB-C+PD.
I'm only attempting two displays, one U2515H (1440P), and one U2720Q (2160P).
I've tried every arrangement possible from the DOCK to the U2720Q, as a single monitor and no matter which port used it always defaults at 30Hz. I've tried known-good Display Port cables (tested on desktop PC using discrete graphics card) and they work fine at 60Hz, I've also done the same tests with the HDMI and USB-C cables directly from the laptop ports and both work at 4K 60Hz no problem.
Once I introduce the dock I cannot reach 4K 60Hz.
DOCK HDMI --> U2720Q = 30Hz
DOCK USB-C+DP (rear port) --> U2720Q = 30Hz
DOCK DISPLAY PORT --> U2720Q = 30Hz
Now, when plugged in via the dock or directly using HDMI or USB-C the default display adaptor is Intel UHD which if I recall on the 11th gen i9 is the newer Xe architecture. Again, plugged in from the laptop (using the same cables) to the monitor, 60Hz all day.
I've tried 130W and 180W dell power delivery and both exhibit the same issue. Doubted it was a power problem, but this should clear that.
Also I've updated to latest Intel UHD drivers, thunderbolt driver, thunderbolt firmware, dock firmware, dell BIOS, intel inf, etc.
Anyone able to crack this nut or are we literally waiting for Dell and Intel to figure out how to deliver what they're selling?
One interesting tidbit from the latest Intel Xe DCH Driver Release Notes for ID 19344 DRIVER VERSION: 30.0.101.1191 in the KNOWN ISSUES section:
"11th and 12thGeneration Intel® Core™ Processors]: Display is getting blanked out with 4K@60hz resolution connected via dock."
We tried reaching you on a private message asking for the Service Tag number to ascertain the warranty but did not receive a response. Please feel free to reply to the private message whenever you are available.
DELL-Cares
Moderator
•
27844 Posts
•
748 Points
567
0
Posted January 11th, 2022 09:00
We tried reaching you on a private message asking for the Service Tag number to ascertain the warranty but did not receive a response. Please feel free to reply to the private message whenever you are available.
#IWork4Dell
For all non-technical issues that require your private data, we must communicate via a private Direct Message
Dell Partner GEM Program, Out of Warranty Support options, No free goodwill repair, Get a copy of your Dell invoice