RustonPaving

updated

14 years ago

0

27753

October 24th, 2012 06:00

MD3200i MPIO

Hi,

I currently have an MD3200i configured with 4 hosts, directly connected without using switches.  I'm doing this as per a diagram provided in the Dell manual.  each server has 2 NICs and 1 NIC from each server goes to each of the 2 controllers on the SAN.  This provides redundancy spread across multiple NICs, cables and SAN controllers while eliminating the switch point of failure.  I'm successfully using MPIO to allow me to lose a link and still keep the host up on the other link.  Hyper-V live migration works great as well.  My concern is that I cannot get both links on each server to go "Active", it'll only do one at a time, so I'm not getting the performance benefits of MPIO.  In doing research I think this is due to the virtual disk only being owned by one controller, and the NIC on that controller is the only one that can go active, the other NIC is put into standby since it's controller doesn't currently own the virtual disk.  Is that correct?  And if so is there any way to get both links to go active while still spreading my hosts over both controllers?  Or do I need to involve switches so the hosts have multiple connections to each controller?

Thanks,

Todd

  • DELL-Sam L

    Community Manager

    •

    8150 Posts

    •

    34715 Points

    926

    1

    Posted October 24th, 2012 09:00

    Hello Todd,

    Yes only one controller can access the lun at a time.  This is done to prevent corruption from both controller reading & writing to the same VD at the same time.  What you will need to do is to get a switch so that you can add multiple connections to the same nic on the controller for the MD & it will allow you to do what you are trying to do.

    Let us know if you have any other questions.

  • 926

    0

    Posted October 24th, 2012 11:00

    Thanks for the confirmation, Sam.  Any recommendations for switches?  I've heard unmanaged switches are in many ways better since they have less overhead and you really don't need all the management features for a dedicated iSCSI network.  I'd get two so the switch doesn't become a SPOF.

    Thanks,

    Todd

  • 322

    0

    Posted February 2nd, 2023 06:00

     

    Good Morning,

    I know the topic is old, but I still use an MD3200i equipment.
    My question is the following, if I connect the MD3200i to the same esxi HOST, with 8 Network Interface, will I get a 4Gbps connection? (4x1GB), and the other 4 ports would be redundant?
    I ask which setting I get the best performance?

    Sorry for my English, I'm using a translator.

  • DELL-Erman O

    Moderator

    •

    2984 Posts

    •

    14874 Points

    316

    0

    Posted February 2nd, 2023 07:00

    Hi, As I can see you replied the same post to more than one case. I've tried to replied one of them on here https://dell.to/3HvutAU Please follow only one case to avoid confusion.

     

    Regards,

    DELL-Erman O

    Social Media and Communities Professional

    Dell Technologies | Enterprise Support Services

    #IWork4Dell

    Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!