zed500

updated

16 years ago

Z

zed500

2 Posts

0

22791

July 24th, 2010 15:00

SAS 6/iR Adapter Properties shows as degraded but the virtual disk shows as ready

I have a new PE T110 with a SAS 6/iR Adapter with 2 SATA 470GB drives configured RAID1.

When I open OpenManage Server Administrator and click on storage it shows the SAS 6/iR Adapter with a yellow exclamation point but the Virtual Disk 0 has a green check mark. I then click on the SAS 6/iR Adapter and the Health shows green checkmarks for Connector 0, Connector 1, Firmware/Driver versions, and Virtual Disks. Then when I click on the Information/Configuration of the SAS 6/iR Adapter it shows the SAS 6/iR Adapter properties with a degraded state but the state of the Virtual Disks and Connectors show as Ready. What would be causing the card to show as degraded?

How do I go about resolving this? Does this mean that the card may be bad?

  • zed500

    2 Posts

    724

    1

    Posted July 26th, 2010 06:00

    I did some digging and found that the storport driver needed to be updated. I had to install MS KB943545 hotfix. Now the SAS 6/iR is showing ready.

  • M_6

    53 Posts

    724

    0

    Posted July 26th, 2010 02:00

    I would make sure the firmware was at the latest level.

    Also check to see if you have a predictive failure on one of the disks.