UNSOLVED

doc413

updated

22 years ago

D

doc413

1 Message

0

10166

January 5th, 2005 18:00

PowerEdge SC1420 & PATA Hard Drives

Hi Everyone,
 
I just purchased a new PowerEdge SC1420.  It came with one SATA hard drive hooked up to SATA_0, and I preceded to install two PATA hard drives and that's where a problem occurs.  I have setup the BIOS for the Primary IDE to "On" for Master and Slave.  The drives are set for cable select.  When I boot up the computer with the two PATA hard drives, the boot-up hangs for a little bit, then proceedes to say that it cannot find either Primary IDE drives.  If I disconnect drive 2, the computer will find the drive 1, and if i disconnect drive 1, it will find drive 2, so I know that the hard drives are not bad.  I can also hook one up to Primary IDE and one up to Secondary IDE and it will find both drives.  I have tried two drives (either 2 HDD or HDD and CD) on the Secondary IDE and it will not recognize either drive.  I was just wondering why I cannot have two drives on each IDE channel like normal IDE channels permit.  I don't see any documentation from Dell to why this does not work.  Is this a BIOS problem that will need to be updated?  Let me know if you guys can help me out...thanks in advance.
 
Anthony
  • sheltonn

    23 Posts

    306

    0

    Posted January 19th, 2005 13:00

    I ran into the same problem with optical drives. I was going to add a DVD reader and a DVD burner to the CD drive. It would only recognize one of them. I verified that the PATA drives were enabled in the BIOS.

    I used XP Pro if that makes a difference.
  • 306

    0

    Posted March 11th, 2005 11:00

    Hi,

    Did you ever solve this issue?