The motherboard on my 2800 blew up and was replaced. The original configuration for the disks was a RAID 5 with a hot spare. The new motherboard does not know of this configuration. I need to retrieve the configuration file from the drives to tell the new perc controller how they are configured. Does anyone know how to do this?
I hate to say it... but the PERC, ID's and firmware revisions are very much relevent... Also, you're assuming he's using the ROMB (hence why I asked what PERC it was). And if it is the ROMB, swapping only the raid key over is simply not enough.
As the drives are SCSI, I hope you do not mix up the drive order, mark the drives before you pull them, know which drives go to which raid channel, if more then one . In SCSI, with the newer raid interfaces, drives can be of a different order on a per channel basis (drive roaming), but drives placed on a channel can not be moved to a different channel; channel roaming is not permitted. So any drive on say channel 0, must be placed onto the channel 0 of the new raid interface. Adhered to this restriction, if your moving the drives to a new controller which is the same or an upgrade which will accept drives from the defunct controller, the new adapter should read the COD (configuration on disk) and startup. You may need to clear any configuration on the new adapter before the COD is accepted. If you place drives on the incorrect channels you have a good possibility of losing the array, the array definitely will not start.
PsychoT
62 Posts
226
0
Posted June 13th, 2008 19:00