I replaced my T110's 2GB with two 8GB DDR3 DIMMS, and it won't POST. The memory is non-ECC, but I read that shouldn't be a problem. Is there something I'm missing? Should it be simply a matter of taking out the old and putting in the new, and turning it on?
I "read" that it didn't have to be ECC on "Crucial.com's" memory configurator. Since crucial is pretty reputable I took away the impression that it "shouldn't be a problem." Perhaps they were wrong? They did say it could take ECC or non-ECC but that you can't mix.
Crucial does a pretty good job, considering the number of systems they have information on, however, they have been wrong on a number of occasions ... though I would still call them the best third-party memory information site. Nothing beats the word from the manufacturer though.
The statement about non-ECC vs ECC seems to be more of a generalization rather than specific to the T110 ... and is odd, since there are almost NO systems that will take both (almost, because they do exist, but there are just very few). Looking through their results, however, all of the memory suggestions they give are ECC.
Also, the documentation for the T110 says nothing about being able to take non-ECC, listing unbuffered ECC memory as the supported memory type.
<ADMIN NOTE: Broken link has been removed from this post by Dell>
theflash1932
11 Legend
•
16255 Posts
1226
0
Posted March 19th, 2011 17:00
Also, max RAM for a T110 is 16GB ... I seriously doubt it will take 8GB DIMM's. 4GB DIMM's are the largest as per original specification on the T110.