The server is a Dell Poweredge 2550 with a Intel 10/100 Nic built into it.The server operates nominally for awhile and then randomly and for pretty much no reason what so ever, this box simply vanishes from the LAN, the link light it still active, but any traffic in or out of the server is just 'dead', to recover it from this I simply disable and re-enable the network interface (it is windows 2000 server) I've gone through the switch to make sure that I didn’t have the IP addresses routed to two separate interfaces or anything funny, and I don’t have multiple routes in my core.
The server has the Intel 10/100 and the Broad(com??) GBe port on it, In my case I am using the Intel card, and I have gone into the 'driver settings' in the system control panel and disabled the option for 'allow this interface to shutdown to conserve power' (not verbatim, but similar). The Intel nic driver I am using is version :6.1.3.0 2/25/03.
I'm not running SNMP, or any of Dell's management software, or anything, i saw a huge thread about the problems with that. I've called technical support about this and they had no clue what to tell me.
Does anyone have any suggestions, this issue is very confusing for me, maybe not as confusing for you.
I would recommend the latest driver. If that still fails, try the BroadCom NIC. It will slow to 100 if required by your network. I will include the drivers for both:
Intel PRO Family of Adapters, Driver, 2000, v.6.0, A06 Filename: Intel_LAN_60_W2K_007.exe [16.68 MB] Release date: 12/18/2002
<ADMIN NOTE: Broken link has been removed from this post by Dell>
Sorry for the confusion. The driver I mentioned is the latest on our website which have been validated by Dell engineering. Intel does have later drivers, I just cant officially recommend them.
Everything is fine on a cisco switch. When I move either the intel or the broadcom card to an alpine 100mb switch, the after a few minutes all conectivity is lost. I am still able to ping the server! The machine becomes very slugish and hangs, the only way to recover is a hard reset.
It is NOT just related to the Intel Cards - I just switched over to a USB LinkSys Adapter and sure enough, after about 2 hrs of successful networking, I lost my connection there as well.
Does anyone from Dell (or anywhere) have any ideas on this?
On my PE2650, one of the Broadcom cards has a public IP connected through an 8 port unmanaged Linksys switch (not router) and the other Broadcom card has a private IP connected through a Baystack 24 port managed switch. I have swapped the IPs and the cables and ... surprize, only the public interface goes to sleep !?!?!
Have I really added some usefull info to all this or...
That is what I was seeing as well. My 600SC is connected to both my local hub and my cable modem. Only my cable modem goes down - since I KNOW that modem is only 10 MBps and half-duplex, I have switched it to use that exclusively (as opposed to auto-detected) to see if that is the cause.
DrewWeaver
2 Posts
467
0
Posted March 28th, 2003 13:00
I'm running a version newer than the one you suggested? So how could that one be the latest version?
The one you listed is from 12/18/02 and im running one from 2/25/02.
??
I'm a little confused.
-Drew