Intel GMA 900 Chip - not able to run 1920*1200 @ 2407WFP
Hello,
I use to have an Toshiba Tecra A3 Notebook with build in Intel GMA900 Videocard. Connected to the Dell 2407WFP (with current drivers installed videocard and monitor) I only could choose 1600*1200 from the settings.
The Notebook sould be able to run the resolution of 1920*1200 without any problems but I can't choose this settings.
On board graphics are usually not up there with stand alone types. Your graphics card most likely won't support above this resolution, if it does, it may not have the power to do it. Heaps of pixels moving on a 1920x1200 screen...
Toshiba says it is able to run 1920*1200 at the d-sub port - than this should work ... it is just a matter of time that i got a macmini oder macbook - they can do 1920*1200 with minidvi ... but till than I have to use that lousy toshiba notebook :/
I assume that you right clicked on the desktop etc to get at your adapter & checked the resolutions that are mentioned there. These are what - usually- what your monitor can support & we all know the native res. of the 2407 is 1920x1200. I also assume that the refresh rate is set at 60hz. Also the 2407 works best on d-sub???
With my Toshiba Tecra A3 Notebook i can only choose 4:3 aspect ration resolutions 1600*1200, 1400*1050, 1280*1024, ... no widescreen available to choose from. I usualy good in finde solutions for those problems ... but i didn't found one in 2 days of research. I have even used powerstrip and try to overwrite settings ... with no result ... (with the notebook I could only connect with d-sub). The screen works well with d-sub and dvi from other computers.
KevinR100
642 Posts
291
0
Posted August 12th, 2006 01:00