UNSOLVED

ktm54b

updated

21 years ago

Closed

K

ktm54b

1 Message

0

14765

June 25th, 2005 02:00

water spill - monitor not working

I recently spilt water on my 5100. the spill went in the pci slot and a little bit on my keyboard. i told my friend not to touch it or turn it on which she continued to try to turn it on four or five time.......i opened it up drained all the water out and said not to touch it now for a day or 2 and she turned it on immediatly after i said it. i let it dry out for a day after that and now when i turn it on it sounds like its starting up the lights come on, the fan turns on the cd player pops out but the monitor doest work... any suggestions?
  • NemesisDB

    2 Intern

    •

    7944 Posts

    712

    0

    Posted June 25th, 2005 03:00

    it's likely dead.  if you want, you can open it up and try to remove any visible corrosion from the board.  do a search for cleaning and alcohol.
  • Teckinno

    39 Posts

    712

    0

    Posted June 25th, 2005 06:00

    I'm sure next time she will listen to you. Tell her to deal with it since she didn't listen to such obvious instruction.
    Nemesis, I don't think the water created any corrosion in such short time, most likely a chip that shorted due to the high conductivity created by the thin layer of water on the board.

  • chaistt

    797 Posts

    712

    0

    Posted June 25th, 2005 07:00

    Hope she had complete care warranty!

     

  • NemesisDB

    2 Intern

    •

    7944 Posts

    712

    0

    Posted June 25th, 2005 14:00

    I've only had one spill on a toshiba lappy that was on at the time.  openned it up and there was significant "corrosion" (for lack of a better term) around the keyboard controller chip.  Scrubbing it off and cleaning allowed it to boot occassionally.  It was never that stable after that though.
  • Teckinno

    39 Posts

    712

    0

    Posted June 25th, 2005 17:00

    Thanks for the info, I had no idea. Probably the water layer acted as a resistor and turned the plate coroded?
  • NemesisDB

    2 Intern

    •

    7944 Posts

    712

    0

    Posted June 25th, 2005 17:00

    electronics ain't my area ;-)
  • 712

    0

    Posted June 26th, 2005 05:00

    give it enough time that it'd normally boot in to windows, then try pressing hte capslock key see if hte light go's on and off.  (arg i can't spell "the").
     
    If hte caps (frick) light doesn't come on, then the system isn't posting, and your issue is worse, but if it does come on, it may just simply be the monitor or hte cable (arg still can't type - i'm gonna try sitting almost upright).
     
    Another simple solution if you have an extra monitor, is to hook up an external monitor and see if you get any display with it.