UNSOLVED

geneman

updated

23 years ago

Closed

G

geneman

5 Posts

0

7669

November 4th, 2003 01:00

8100 Video Starting to Go Bad

All,

 

I have a nearly two year old Dell Inspiron 8100 with the Radeon 7500 64 MB video adapter

and would like some advice about what might be going wrong with it and what I might be

able to do to save it.

 

What is starting to happen is that my display, either when I boot up, or after some period of

use, starts to deteriorate.  By deteriorate, I mean that I get columns of thin horizontal lines

across the display.  Their effect can vary from annoying to making the laptop unusable.  Moving

the LCD around makes the patterns shift a little and can sometimes make them disappear for

a short while.  The problem seems to get worse as the laptop heats up and, if it is going to start

at bootup, it starts at the blue Dell screen that appears before windows even loads.

 

I am somewhat handy, at least around desktop units, having installed power supplies, CPUs,

memory, disk drives, CD-ROMS and the like - if I had some diagrams about how to take the

Inspiron 8100 apart and some idea what might need to be replaced, maybe I could make some

headway.  As it is, I really think that my Inspiron will soon be useless unless I do something.

 

Any ideas:?

 

Thanks,

Geneman

 

  • 294

    0

    Posted November 4th, 2003 01:00

    I had a similar problem with my problem with my Inspiron 8100 until recently, I had to go inside my notebook using the instructions on this site and remove the video card and cable going to the LCD screen and reinsert it. Once I did the everything is now fine. Maybe this will work for you too.

  • Rollie_R

    2 Intern

    •

    2248 Posts

    294

    0

    Posted November 4th, 2003 13:00

    Geneman,

    Thank you for using the Dell Community Forum.

    Attach an external monitor to the VGA port on the back of the system. Then using the Fn-F8 key combination, toggle the video signal to the external monitor and see if the display is good on the external monitor.  Check if the same problem appears on the external monitor.  If you have an intermittent problem, then you need to use this configuration until the problem appears. 

    This sounds more like a problem with the LCD, or the cabling for the LCD.  If the external video is good, then there is no reason to remove the video card, but you may want to reseat the video cable.  There may also be a problem inside the LCD, either with the cabling, or the inverter.

     

  • geneman

    5 Posts

    294

    0

    Posted November 4th, 2003 19:00

    Excellerator,

    Thanks for the suggestion.  I had tried a search for schematics on how to open up the laptop (there are a lot of different small screws, as you no doubt know) but didn't find anything.  Is the information you reference on forums.us.dell.com or on the main dell website?

    Thanks,

    Geneman


     

  • geneman

    5 Posts

    294

    0

    Posted November 4th, 2003 19:00

    Rollie,

    Thanks for the suggestion.  I had already tried that, but got a result that didn't (at least to me) provide much illumination on the problem.  I had expected to either get a good display or the same bad display that I had on the LCD, but that is not what happened.  If I were to characterize what happened, I would say that the external monitor looked like a TV where the horizontal hold (an control once found on TVs) was out of adjustment.  In other works, the display looked like the picture had been divided into lines running at about 20 degrees above horizontal, from upper left to lower right.  Very strange.

    Thanks,

    Geneman

  • 294

    0

    Posted November 5th, 2003 11:00

    Here is the link I used to get my troubles fixed. Hopefully it works for you.

    http://docs.us.dell.com/docs/systems/ins8100/remove.htm#1051438

     

    Excellerator

  • geneman

    5 Posts

    294

    0

    Posted November 5th, 2003 20:00

    Excellerator,

     

    Thanks for the link.  I did a search there, found the instructions, disassembled my laptop, reseated

    the videocard and it's connectors and presto!  It has not malfunctioned since.  Thanks a million.

     

    Geneman