UNSOLVED

KeeneS

updated

23 years ago

K

KeeneS

12 Posts

0

7505

October 28th, 2003 15:00

GX150's, Ghost, & Sysprep

Hi, all.

We've built a W2K Ghost image on a GX150 (shipped 7/2002).

When we ghost that image onto some older GX150's we have (shipped 8/2001), W2K starts up but then immediately hangs as soon as the "Starting Windows..." bar completes.  You can F8 to get into the Advanced Options menu, but no matter what you pick it still hangs.

If I pull the hard drive out of the older GX150 and hook it up in the newer GX150, W2K boots up fine, so it's not the hard drive or a corrupted image.  I'm assuming that the hard drive controller must be different enough between the two computers that it's freaking Windows out.

I've been experimenting with Sysprepping the OS on the master GX150 before dumping the image, but so far I haven't had any luck.  We've never used Sysprep before.  We're just now moving our GX150 public computer image from Win98 to 2K, and apparently Win98 wasn't as picky about the image.

I thought the point of the Optiplex line was that the hardware is supposed to stay the same for the life of the model, so that enterprise customers wouldn't run into problems like this when using imaging software...

Any help would be appreciated.  Thanks.

-- KEENE

  • KeeneS

    12 Posts

    169

    0

    Posted October 29th, 2003 15:00

    Sorta.

    I figured it out.

    When I was comparing BIOS settings, I found that the older batch of GX150's we bought had the Integrated Devices-->IOAPIC Support set to disabled.  The newer ones apparently came with that setting enabled by default.

    I enabled it in the BIOS on the older 150's and the image works fine now.

    Whew... 

    -- KEENE

     

  • KeeneS

    12 Posts

    169

    0

    Posted October 29th, 2003 15:00



    @droid256 wrote:

    To fix your image you will need to change the HAL to the Advanced Configuration and Power Interface HAL by going through device manager and the computer type.


    You're right.  You can do it that way too.

    If you go in and change it that way in device manager, then it doesn't matter if you have IOAPIC Support enabled or disabled in the BIOS.  You just need IOAPIC Support enabled if you have the computer set as an ACPI Uniprocessor in the device manager.

    Thanks for the help.

    -- KEENE

     

  • droid256

    73 Posts

    169

    0

    Posted October 29th, 2003 15:00

    There were two different versions of the GX150. Dell provided lots of notification about the two versions.  The problem is the older GX150 is not capable of running the APIC HAL(ACPI Uniprocessor).  Since you built your image on a newer GX150, it most likely installed the APIC HAL by default.

    To fix your image you will need to change the HAL to the Advanced Configuration and Power Interface HAL by going through device manager and the computer type.

    Droid

  • viponly

    10 Posts

    169

    0

    Posted October 1st, 2004 20:00

    I have clean Win2K SP2 unit which I build on a GX270 and I'm having the same issue with the GX150.  Can you please tell me where in Device Manager I can change APIC HAL?  Nowhere in device manager allows me to change anything.  All I can do enable or disable a device. 

    Message Edited by viponly on 10-01-2004 04:03 PM