UNSOLVED

DblDamage

updated

15 years ago

D

DblDamage

2 Posts

0

7795

February 25th, 2012 12:00

M11x R3 "NON-SYSTEM DISK" message after Seagate firmware upgrade

Last night I installed the Seagate ST9500423AS firmware upgrade for my M11x R3.  Ever since then, whenever I restart the computer, I get a single loud beep and the message "NON-SYSTEM DISK..PRESS ANY KEY".  Once a key is pressed, the system boots normally into Windows.  I tried reloading the default settings in the BIOS, but that doesn't help.  I think a CMOS clear might work, but I can't find instructions on doing that.

Any suggestions on fixing this minor annoyance would be greatly appreciated.

~DblDamage

  • goonielife

    90 Posts

    378

    0

    Posted February 25th, 2012 15:00

    Check the boot order in the bios. See if anything is listed before the Seagate.

    Clearing the cmos would just reset the bios to defaults, doing it within the bios should give you the same results.  You really only need to do that if you can't get the system into the bios.

  • DblDamage

    2 Posts

    378

    0

    Posted February 26th, 2012 17:00

    The firmware update corrupted the Windows bootloader.  After much weeping and gnashing of teeth, I was able to restore the BCD from a backup on the Recovery partition.  This fixed the annoying beep and NON-SYSTEM DISK error I used to get, but I still cannot access any pre-boot menus (safe mode, recovery, etc) by pressing F8.  I'm considering running AlienRespawn to go back to a factory image to try and fix it.  Does anyone know if the 39MB OEM partition has any bearing on the bootloader?