UNSOLVED

benjack71

updated

11 years ago

B

benjack71

22 Posts

0

9400

August 7th, 2015 10:00

Alienware 17 (Mid 2013) boot/reinstall problems

My Alienware stopped wanting to boot up. It would just go to a black screen. I attempted the recovery through the hard drive partition and also tried my rescue discs. All that would happen is that it would get to the setup is preparing your computer for first use and stop. The other thing is like an idiot I messed around with my Drive configurations. It came with a 64gb SSD with a 600 gb hdd. I am not sure how to configure my disks. Should I have SATA set to raid in the bios? Should I create a RAID drive with the SDD and HDD? If I do it knocks my RAID to 161 GB. That's not right. I know I had 688 GB showing on drive C before this all started. So, how do I configure my discs for starters? After that what would be the solution to the hanging laptop?

  • Alienware - Rodrigo

    9 Technologist

    •

    4398 Posts

    716

    0

    Posted August 7th, 2015 12:00

    Hello, 

    The 64GB SSD was most likely set as a cache device for improved performance and that would mean that the 600GB HDD should be your primary drive where you would install Windows. For this configuration, you should have the SATA mode set to Raid in the Bios.

    However, you do not need to create a Raid configuration with the 2 drivers. The only thing that needs to be done after reinstalling Windows, is to enable caching on the 64GB SSD. Click here to view a Dell article that explains how to do this with the Intel Rapid Storage Software. 

  • benjack71

    22 Posts

    716

    0

    Posted August 19th, 2015 00:00

    Yes, understand that. So, I have my alienspawn recovery discs. When I try to use them all seems fine. Until windows starts after the reformat and reinstall. It gets to the setup is preparing your computer for first use screen and stays there. Its maddening. Any ideas? I want to go back to factory state if I can