D2LR

updated

16 years ago

D

D2LR

7 Posts

0

1311

September 30th, 2010 08:00

What is the recommended Management Port Speed on CX4 SP's?

I noticed that both the SP's in our CX4 - 480 have the requested Management Port Settings set at Auto with the Link Status  showing at 100 Mbps/Full Duplex.

The switch ports that they are connected to are set for Auto and show as connected at  1000 Mbps/Full duplex.

We have been having performance issues recently - couldn't connect to SPA, couldn't perform SP collects etc.

I am wondering if this discrepancy is a possible cause of the issues we have been experiencing.

Thanks for your response,

  • 757

    0

    Posted September 30th, 2010 12:00

    Setting both ends to either 100Mbps/full (or 1000Pbps/full) is acceptable as long as they both match.  Sorry for the confusion.

  • D2LR

    7 Posts

    757

    0

    Posted September 30th, 2010 11:00

    Thanks Brent,

    Why set both ends to 100Mbs/full  instead of both ends to 1000Mbs/full? Any technical reason?

    Thanks,

    Rick

  • 757

    0

    Posted September 30th, 2010 11:00

    I would manually set both ends to 100Mbs/full in order to avoid the issue you see.

    CX4-series arrays - The management LAN port speed and duplex settings can be changed to match LAN switch port settings using either of the following methods:

    Note: Changing the settings on the CX4 will not cause the SP to reboot and can be changed online.

    Change the SP management LAN port settings through the SP/setup page:

               1. Open the setup page for SP A/SP B on the array.

               2. In the IP settings field, change the Required Speed Settings parameter to match the LAN settings.

               3. Select the Apply Settings button.

          Change the SP Management LAN port settings through the Navisphere GUI:

               1. Log in to the array from Navisphere GUI.

               2. Right-click SP A/SP B, and open Properties > Network tab.

               3. In the Management Port Settings field, change the Requested Settings parameter to match the LAN settings.

               4. Select the OK button.

          See Knowledgebase article emc208577 for further details.

  • D2LR

    7 Posts

    757

    0

    Posted September 30th, 2010 12:00

    Excellent.

    Thanks for your input.