Directing connecting a host to FC connectors on a NX4
Hi guys,
I'm wondering has anyone directly connected the NX4 to a FC switch using the 2 FC front-end connections on the intergrated SPs? I would like to use the fibre channel connectivity.
ran nas_volume -list selected the disk and ran nas_volume -info "disk" confirmed that the disk was not in use deleted the virtual disk by running nas_disk -delete "diskX"
that should have been "nas_disk -delete diskX -perm"
ok lads - got this working. I added the FC frontend ports to a FC switch and zoned in a host. Under the navissphere express gui I manual registered the host with the storage array.
SSH into the control station
ran nas_volume -list selected the disk and ran nas_volume -info "disk" confirmed that the disk was not in use deleted the virtual disk by running nas_disk -delete "diskX" under Navissphere GUI i removed the lun from the control station SG and added it too the host.
Cheers... trying this out on a test enviroment at the moment. If I dont use the -perm command does the system_config restore the disk configuration to factory default?
Unless -perm is specified, the disk is still identified as a Celerra disk and can be discovered and marked again using server_devconfig.
The -perm option removes the entry from the disk table and deletes the diskmark. The disk is then available to be deployed for use by another platform.
not exactly sure if Celerra will be throwing errors every time you are trying to rescan, trying to look for that LUN.
I'm a very dissatisfied NX4 customer. My sales agent at SoftChoice found this as an option for us. We only wanted a huge array with big disks and a fat pipe. We were looking at an AX4-5i but he found the NX4 to be ODDLY cheaper as it has an AX4-5F8 built in. It has been a nightmare. Some day, we may use this info and remove the power from the data mover and the control station and just use the Clariion with HBAs (yet to buy)
dynamox
11 Legend
•
20419 Posts
•
87439 Points
446
0
Posted October 13th, 2009 07:00