Endurance isn't the issue, IMHO, as much as speed and size with respect to protection.
It's a trade off. Unless you have full stripe writes (which I never assume when sizing a system. If we get them, it's better than expected, but I don't count on that to get to the performance I need), you will pay a higher write penalty with RAID 6 than RAID 5. This makes sense because you have 2 parities to handle instead of 1 per stripe. Reads are effectively the same since I don't care about parity when reading (assuming I'm not degraded). What you get for that penalty is better protection. Once I lose a drive, I care about how long I'm exposed with respect to the next failure for performance but more importantly for data integrity. NL-SAS drives are slower and typically bigger which means the rebuild will take longer, in some cases significantly longer, than SAS drives. This is why having the extra protection of RAID-6 is good And if I'm willing to put data on NL-SAS drives, that data is typically not as performance sensitive as data I might put on faster drives so I'm more willing to take the write penalty in exchange for the better protection. The same holds true for RAID width. I have to do more reads do rebuild a 14+2 R6 than a 6+2 R6 so that can affect my rebuild time. I also have less of a chance with bigger workloads in getting those full stripe writes with 14+2 unless I know I'm doing large sequential writes, which is not a typical workload for most applications, in my experience.
Roger_Wu
6 Operator
•
4025 Posts
519
0
Posted March 9th, 2014 18:00
You can refer to the whitepaper for more details: http://www.emc.com/collateral/software/white-papers/h10938-vnx-best-practices-wp.pdf
RAID 6 is good for SATA disks. For SAS disks, RAID 5 is enough.