RApel1

updated

16 years ago

R

RApel1

11 Posts

0

3547

October 27th, 2010 12:00

symclone restore parameters

Need help crafting symclone restore parameters.

1) Our initial setup of symclone is:  symclone -d create -precopy -differential -exact -tgt -nop

2) To active initially                        symclone -d activate -tgt -nop

Daily routine for symclone is as follows

3)  symclone recreate -d -precopy -tgt -nop

4)  symclone activate -d -tgt -nop

My understanding is that you restore while in activate mode.

My understading is that you can perform a differential restore.

what parameters do I need for the symclone restore procedure

do I need in case I need to restore from the target volumes?

  • dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    1593

    0

    Posted October 27th, 2010 15:00

    yes, your symclone has to be in activated state, and the actual device state should be "Copied". The command to restore is:

    symclone -g restore

    after restore is complete you will need to run "symclone split" to be able to run "symclone recreate" again.

  • RApel1

    11 Posts

    1593

    0

    Posted October 28th, 2010 04:00

    Do I have to append any other operands such as -tgt,  or will the command automatically pick all the target device for the restore?

  • dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    1593

    0

    Posted October 28th, 2010 04:00

    sorry, i don't remember if you have to use -tgt for restore ...i typically use device files for clone operations. That should be easy to test though with a pair of un-used devices.

  • RApel1

    11 Posts

    1593

    0

    Posted October 28th, 2010 05:00

    Thanks for the reply.

    Rick A

    >>> dynamox restore

    after restore is complete you will need to run "symclone split" to be able to run "symclone recreate" again.

    Reply to this message by replying to this email -or- go to the message on ECN ( https://community.emc.com/message/509556#509556 )

    Start a new discussion in Symmetrix by email ( mailto:discussions-community-support-symmetrix@emc-developer.hosted.jivesoftware.com ) or at ECN ( https://community.emc.com/choose-container!input.jspa?contentType=1&containerType=14&container=2449 )