UNSOLVED

Tom Seeley

updated

19 years ago

TS

Tom Seeley

22 Posts

0

1657

May 18th, 2008 14:00

Confused about installing a DVD burner in my Dell

I bought a Samsung DVD burner last night but when I tried to install it, I got confused by what I found inside my Dell.  I've got a Dimension 2400 series with a CD burner (not a DVD) and a 3.5 floppy drive installed, and what looks like one spare slot I had hoped to use to install the DVD burner without taking out either of the drives I already have.

 

Trouble is, the Samsung instructions make it appear as if I need the EIDE cable, a power cable, an audio cable, and a cable the instructions simply call a digital cable.  There are slots for all four of these on the back of the drive. 

 

But when I opened up the Dell, all the cables I could find were already hooked into either of the two drives I already have.  I don't want to remove either of them simply to make EIDE or power cables available for the DVD.  And I have no clue at all what to do about the two other cables Samsung shows in their very meager instructions.

 

What am I doing wrong?  Did I simply buy an unsuitable DVD burner?  Should I be looking for a different brand?  Or is there a way to do what I'm trying to do with the drive I bought?

 

The other issue I ran into would seem to be I don't know how to remove the CD burner that's there now, if it's fastened with screws on both sides!  The access panel on the Dell only provides me access to one side of the drives.  If I had tried to remove the CD burner, would I have been able to, or would I have NOT had access to a pair of screws on the back side!?

 

This is getting harder than it's worth, since right now all I really want to do is convert one old family VCR tape to DVD! 

 

Thx

 

Tom

  • Digital28

    278 Posts

    282

    0

    Posted May 18th, 2008 15:00

    Download your service manuel here:

     

    http://support.dell.com/support/edocs/systems/dim2400/en/index.htm

     

    Cheers, Dave 

  • Digital28

    278 Posts

    282

    0

    Posted May 18th, 2008 15:00

    Replace the existing CD burner with the new one using the existing cables or if you have an additional cable connection on the EIDE for a second drive and another empty power cable, use those to install into the second empty optical drive bay.  The new drive will also burn CD's so your old drive is not really needed plus the new drive probably will be faster!  

     

    The digital cable and audio cable is not really needed has been my experience.

     

    Cheers, Dave 

  • Digital28

    278 Posts

    282

    0

    Posted May 18th, 2008 15:00

    Removing the old drive is accomplished by removing screws that you can see from the side panel that comes off and then removing the front cover of your system.  The front comes off by releasing a couple of tabs that you can reach after removing the side panel.  Front then swings off and the optical drive can be removed after removing the cabling.

     

    Cheers, Dave