I'm using this version because in the other site I've a AP7600 splitter with 6.4.1a.
I've made the zones and I could see the RPA wwn logued in the Vmax and the RPA see the vmax wwn as a target. But it Couldn't see any lun, even the GK and the aclx.
The FA ports are set up correctly.
I will appreciate any help.
Andres Nourian
Emc Argentina
De: forshr
Enviado: Thursday, December 13, 2012 07:16 AM
Para: Nourian, Andres
Asunto: New message: "VMAXe 5876 splitter and Recoverpoint 3.5.0.2"
EMC Community Network
Re: VMAXe 5876 splitter and Recoverpoint 3.5.0.2
created by forshr in RecoverPoint - View the full discussion
Firstly I would advise that you upgrade RP the latest version, 3.5 SP1 P1, as there are some enhancement to VMAX splitter code in this release.
The 'SAN view is empty' message is simply implying that the RPAs cannot see any LUNs. Therefore, can you confirm that you have performed the necessary zoning requirement (all RPAs must be zoned to the same FA ports as the hosts) and the masking view configuration has been set up correctly which should include the creation of the initiator group, port group and storage group. Please note that LUNs must be exposed to the host and the RPAs through the same FA ports.
You may want to refer to the RecoverPoint Deploying with Symmetrix Arrays Technical Notes document for reference.
Please refer to the RecoverPoint Deploying with Symmetrix Arrays Technical Notes document which is available for download from PowerLink.
I own this document and I would advocate that you read through it at your earliest convenienve in order to asist you with this deployment. It could save you a lot time and potential issues.
I was confused with the Write Protect Bypass (WPBP).
I´d read the document. In reference to this sentence is that I made the mistake.
"After upgrading to Enginuity microcode 5876 or later, the WPBP flag is ignored by the microcode and cannot be enabled. It may be disabled with no consequence. "
I thought it was in reference of Device Tagging and it was about WPBP.
Thanks for your support. I will try Decive tagging tomorrow.
AndersN2
13 Posts
1051
0
Posted December 13th, 2012 04:00
Hi Forshr,
I'm using this version because in the other site I've a AP7600 splitter with 6.4.1a.
I've made the zones and I could see the RPA wwn logued in the Vmax and the RPA see the vmax wwn as a target. But it Couldn't see any lun, even the GK and the aclx.
The FA ports are set up correctly.
I will appreciate any help.
Andres Nourian
Emc Argentina
De: forshr
Enviado: Thursday, December 13, 2012 07:16 AM
Para: Nourian, Andres
Asunto: New message: "VMAXe 5876 splitter and Recoverpoint 3.5.0.2"
EMC Community Network
Re: VMAXe 5876 splitter and Recoverpoint 3.5.0.2
created by forshr in RecoverPoint - View the full discussion