Past the first screen, ACUwizard reports in 'System Info' the following:
- Intel AMT on this system: Supported
- System Configuration state: Not Configured
- Release: 8.1.72.3002
- Client Control mode: Supported.
1) If I try to 'Configure via Windows', then go through the configuration steps, click 'Configure' and wait, the ACU Wizard goes through 'Configuring System', 'Getting system data' and fails with:
"Failed to complete the Setup operation on this Intel(R) AMT device.
....
The SKU version is not supported'.
2) if I try to use a USB key, the profile gets created successfully but nothing happens when rebooting the machine.
3) During POST, pressing '[CTRL]+[P]' results in a yellow message in the top right corner of the screen which reads 'Preparing MBEx menu' (That's from memory) but nothing happens either and the system boots normally.
Am I missing something obvious? Is there a specific version of the ACU wizard to configure AMT on a Dell Precision T5610?
Really at loss here, any help would be apreciated.
Since this is an on-board component, I'm guess the only way to 'solve' that is to replace the mainboard.
1) Is this solved by replacing the Mainboard with a motherboard that has ME enabled or are there other components that need to be replaced as well?
2) In the case of a new T5610 motherboard.. How do I know if ME is activateable ? I wouldn't want to buy another mobo on ebay and find that it had 'ME DISABLED' as well.
3) Are there specific motherboard revisions for the T5610 that I should look for? Most of the board out there seem to be of this revision: WN7Y6
JST01
4 Posts
4719
0
Posted April 5th, 2018 04:00
Please check on Boot Menue ( Pressing "F12" while Dell Logo appears on boot screen )
AMT is only available on your mainboard if you find a menue point like
"Intel(R) Management Engine BIOS Extension ( MBEx )"
otherwise no AMT was sold with your system and AMT not available.