Yes the R520 can support the TL4000 with 4xLTO6 drives. Here is a link to the Compatibility Matrix for all tape devices & if you look on page 6 it list out the server with the correct HBA that it supports. ftp://ftp.dell.com/Manuals/all-products/esuprt_ser_stor_net/esuprt_powervault/powervault-tl4000_Reference%20Guide9_en-us.pdf
The only thing that I would say to watch out for is that when you configure your backups that you allow bout 5-10 minutes in between start times so that the robot can get the tape & put it in the drive & put any tape that it may need away. I have seen in some instances that when multiple jobs are set to start that you will get a queued status for a few minutes until the robot goes to the home position so that the next job can start.
Please let us know if you have any other questions.
Sorry to bump this old thread. Do you have a picture or guidance on how to connect all 4 drives (dual port) to one or two dual sas cards in a single server? (stacking sas?, use only port A in the tl?)
DELL-Sam L
Community Manager
•
8147 Posts
•
34706 Points
536
0
Posted August 27th, 2014 06:00
Hello Paul,
Yes the R520 can support the TL4000 with 4xLTO6 drives. Here is a link to the Compatibility Matrix for all tape devices & if you look on page 6 it list out the server with the correct HBA that it supports. ftp://ftp.dell.com/Manuals/all-products/esuprt_ser_stor_net/esuprt_powervault/powervault-tl4000_Reference%20Guide9_en-us.pdf
The only thing that I would say to watch out for is that when you configure your backups that you allow bout 5-10 minutes in between start times so that the robot can get the tape & put it in the drive & put any tape that it may need away. I have seen in some instances that when multiple jobs are set to start that you will get a queued status for a few minutes until the robot goes to the home position so that the next job can start.
Please let us know if you have any other questions.