I have a PV745N with the PERC controller using both chanels going to a PV220s. I installed a 39160 card in the second PCI slot. I am using 1 channel from that card to another external storage device. The 745 has the SATA daughterboard config with a software raid handled by windows. I have 4 drives installed. The first 2 are in the original raid from the factory. The other 2 are in a stripe. When the second 2 drives are installed, the system gets halfway through the boot and i get STOP error 0x0000050 in adpu160m.sys driver. BUT if I boot up without those 2 drives installed, it boots fine. I can then insert the 2 drives while in windows, reactivate the disks in drive management, and everything works great. But when I reboot, BSOD again. any ideas?
Dell has only certified the PV745N for use with a single PERC (dual channel) to connect to a PV220S.
If you're adding even more external storage space on a 39160, this isn't something Dell has certified/tested, possibly because of what you're running into (maybe not enough power from the PSU at boot/post if all devices connected when disks are spinning up and such), or just because it wasn't intended to be used like that.
One other thing is that dynamic disk is supported, but personally, I don't like crossing 'enclosures' when using dynamic disks, as 1 fault in 1 of the enclosures can cause you to lose all the affected data. It's usually better to implement smarter disk management thru mount points or setting up multiple shares.
Thanks for the reply, I do understand about the whole warranty/being certified thing, etc. I read another post from you where you suggested to someone to get a 39160 for the pv745 for a similar set up. Also, you must have misunderstood me, i am not using dynamic disk "crossing enclosures" like you said.
Dev Mgr
6 Operator
•
9308 Posts
•
3 Points
115
0
Posted November 23rd, 2005 14:00
If you're adding even more external storage space on a 39160, this isn't something Dell has certified/tested, possibly because of what you're running into (maybe not enough power from the PSU at boot/post if all devices connected when disks are spinning up and such), or just because it wasn't intended to be used like that.
One other thing is that dynamic disk is supported, but personally, I don't like crossing 'enclosures' when using dynamic disks, as 1 fault in 1 of the enclosures can cause you to lose all the affected data. It's usually better to implement smarter disk management thru mount points or setting up multiple shares.