PE2950 I Windows install hangs on "Starting Windows"
Gentlemen,
I recently accuired a PE 2950 Gen I server. When I boot I can configure remote access and the raid controller. Then the systems boots the OS from the optical drive. This goes well (preparing or copying files) tough when windows launches the "starting windows screen" the system hangs.
Configuration:
PE2950 gen I
Perc 5/i
1 SAS 73.5Gb drive (did some test with additional drives to but that only complicates the mater) on wich we created a 1 on 1 VD for the controller
32Gb Ram DDR2 FBDimm at 667MHz
Bios: 2.70
Baseboard managemet: latest 2.3 (do not recall exactly)
Xeon 3Ghzz 5000 series at 667
Windows 2008 Server R2 (Windows Volume Licence Site .Iso)
I tried:
Waiting (an hour no luck)
Server 2012 (same issue)
Booting from Dell OS deployment tools (same issue once windows is being loaded)
Initialising the HDD's before trying to install OS
Ubuntu (works fine)
Does anyone have any options? Preferable to install Win 2012 but Win 2008 R2 will suffice.
New copy of windows 2008 R2: no luck (hangs at starting windows)
Windows PE3: no luck (hangs at starting windows)
Windows server 2012: no luck (hangs at starting windows)
Windows server 2012 hyper-v (the free version): no luck (hangs at starting windows)
Windows 2003 x86: works perfectly (With dell deployment tools)
Windows 2003 x64: works perfectly (With dell deployment tools)
Upgrade from working 2003 x64 to a Win 2008 R2 x64: no luck (install works fine, hangs at starting windows)
Considering the fact that I NEED hyper-v I am running out of options. Only thing that I have left would be to trow the darn thing out of the windows if it weren't so heavy ;-)
Morris, try this, go into the idrac configuration at bootup (Cntrl -E) and choose Virtual Media Configuration, then detach Virtual Media and disable Virtual Flash. That should do it for you.
I might have been mistaken. The remote acces that is present is only of the BMC and no DRAC or I Drac is present. The problem thus should not be linked to this.
(I can press Ctrl-E but that gives me an interface who just configures the BMC ip-settings and not much more)
DELL-Geoff P
990 Posts
2740
0
Posted July 26th, 2013 07:00
You may have a bad installation ISO. You may need to do the following:
◦Download image again
◦Verify hash after download
◦Use a download utility to ensure integrity of file
◦Burn image again
◦Burn image at a slower rate
◦Burn image using different software
◦Burn image using different drive/PC
The hardware is working, since you were able to install Ubuntu successfully. It sounds like the installation media is having issues.
Regards,