RAID1 stuck on 'degraded' mix of SATA & SAS drives
Hello all,
I have an R430 with an H730 mini. I had two 8TB SATA drives in a RAID1 config, all working fine. The SATA drives were 6GB/s and I wanted to replace them with both newer and 12GB/s drives to take advantage of the additional speed the H710 offers.
I purchased 2 8TB SAS 12GB/s drives and *thought* I could simply remove one of the old 6GB/s SATA drives and put in the new (same size) 12GB/s SAS drives and it would rebuild, then pull the other and replace and then keep the array but with the new 12GB/s drives.
In reality what has happened is that I have pulled one of the 6GB/s drives and the Virtual Disks in OMSA has gone to 'Degraded' which I assumed normal and that it would then start to rebuild, but it is stuck at 'Degraded'.
In 'Physical Disks' I see the new drive as 'Ready' but there is no option anywhere to force the rebuild to start.
I was under the impression that as long as the drives were of the same size, I'd be fine doing this and the H730 would simply negotiate to the lowest speed.
Is there a way to force the rebuild, or have I done something wrong?
After a bit of playing around I have seen this message:
Physical Disk 0:1:1: This Physical disk is not suitable to protect all current or potential virtual disks on this controller. Possible reasons include: Insufficient physical disk space, unsupported mix of SAS and SATA type physical disks, unsupported mix of SSD and HDD type physical disks, unsupported mix of 512Bytes and 4KBytes Logical Block size physical disks, unsupported mix of PI capable and incapable type disks and non-SED drive assigned as a GHS when encryption virtual disk is present. Continue with assigning as a global hot spare?
It looks like this might be my problem.
Is there a way I can achieve what I'm trying to do without data loss and end up back in a RAID1 situation with the new drives?
You can not replace a SATA drive with a SAS drives in a virtual disk. New drive need to be same type and family of existing drives. In your case you need to create a new virtual disk with new drives and copy the data from old virtual disk to new virtual disk.
gavin2812
1 Rookie
•
51 Posts
132
0
Posted October 26th, 2022 05:00
After a bit of playing around I have seen this message:
Physical Disk 0:1:1: This Physical disk is not suitable to protect all current or potential virtual disks on this controller. Possible reasons include: Insufficient physical disk space, unsupported mix of SAS and SATA type physical disks, unsupported mix of SSD and HDD type physical disks, unsupported mix of 512Bytes and 4KBytes Logical Block size physical disks, unsupported mix of PI capable and incapable type disks and non-SED drive assigned as a GHS when encryption virtual disk is present. Continue with assigning as a global hot spare?
It looks like this might be my problem.
Is there a way I can achieve what I'm trying to do without data loss and end up back in a RAID1 situation with the new drives?
Thanks.