PE2850 DRAC4/i no video if monitor was plugged to an running system
Hello,
when i powered on the PE2850 (DRAC4/i) there was no monitor or KVM switch connected to the monitor connector. The server runs fine. Now i tried to plug in an monitor to the monitor connector, i tried front and rear port, but there was no video signal to the monitor. When i reboot the server the monitor signal is availble and everything is fine.
Is this normal operation? Or should there an video signal if i connect the monitor on an running system,too?
If you look at the system documentation you'll find the chapter: Connecting External Devices
There is explained:
Always attach external devices while your system is turned off. Next, turn on any external devices before turning on the system (unless the documentation for the device specifies otherwise).
but the content from the link, only to connect devices if system is powered down, is not applicable for monitors, usb devices and plug&play devices, isn't it?
Or is it really normal to connect an monitor only if system powered down in this case?
Are there any other who has experience with this issue?
SteffenG_03082b
9 Posts
219
0
Posted September 25th, 2006 08:00
So it seems your issue is worked as designed.
You can find the whole documentation here:
http://support.euro.dell.com/support/edocs/systems/pe2850/en/ug/t1390c10.htm#wp1043338
Message Edited by SteffenG on 09-25-2006 12:57 PM