
UNSOLVED
A
andygrantonline
8 Posts
0
1458
June 8th, 2017 15:00
Dell PE C6100/6105 Rack Rails question
I have a question about the proper mounting, installation, and use of the king slide rack rails that come with C6100s.
Each and every one of them that we have purchased coming off lease, whether purchased on eBay, or direct from the lease administrators have all come with the same rails. (pictures below).
My question is, as these are obviously the rails available for this server, is there any way to secure them other than the obvious screwing the rails into the posts, and then screwing the screws on the front of the power control panels on the 6100 into the posts as well?
Is there any way to screw these into the sides of the chassis itself?
We had a D.C. that while removing a hard drive caddy from a racked c6100 caused the chassis to fall about 3-4 inches. they caught the chassis and it didn't strike anything, but I cannot figure out how this happened.
Now, the DC does have racks with 20th century round holes, rather than every rack made since 2007 that has square holes, so they sold us replacement posts with square holes. The only thing I can think of is that the posts were not completely secured?
Is there any reason that while removing a HDD caddy the chassis should fall off the rails?
I'd appreciate all responses, especially those from Dell employees.
http://www.ascendtech.us/mmImages/b_0/Y3DX1-02.jpg
http://thumbs.ebaystatic.com/images/g/dfsAAOSwqfNXoc5~/s-l225.jpg
http://files.kyozou.com/Picture.aspx?width=600&height=600&id=17994569
Responses (1)
Solutions (0)

Daniel My
12 Elder
•
6204 Posts
1075
0
Posted June 9th, 2017 10:00
Hello
The instructions are in the getting started guide on the manual page of the system:
www.dell.com/support/home/product-support/product/poweredge-c6100/manuals
Not that I'm aware of, securing the left and right ears should be sufficient for the system to stay in place.
No, I would suspect that either the rack dimensions are not appropriate for the rails or the rails were not properly installed. The lip on the rails should hold the system in place and keep it from falling down. Horizontal movement should not occur if the ears are secured to the rack. The only movement that should be possible would be vertical, and due to the weight of the system that is unlikely.
Thanks