U2725QE, firmware M2T102, unrecognized on Macbook Pro (M4)
I had the Dell U2725QE for a couple of weeks and it worked fine (bar auto brightness fluctuating).
Since I upgraded the firmware to M2T102 it is totally unrecognized when connected directly to my Macbook Pro M4 (Sequoia 15.6).
When connected directly via Thunderbolt (Dell provided cable), it is shows "No Thunderbolt Cable Connected". The Mac charges, but it seems that the display is only seen as a (very expensive and very big) USB-C charger.
When connected directly via HDMI, the display shows in MacOs system settings, but no image shows on the display.
I have tried all resolutions / frequencies from MacOs, nothing will do.
1. Updated the firmware to M2T102, connected to a Windows/PC 2. Unplugged ALL cables from the monitor (not just the power cable) 3. Waited 15 minutes 4. Held the power button on the monitor for 15 seconds to completely drain any left over power 5. Connected ONLY the power cable, and turned the monitor back on 6. Connected ONLY the Thunderbolt cable from the 140w port to the Mac, and switched the input source to Thunderbolt on the monitor. The Mac screen appeared! 7. Connected all other cables and adjusted the rest of the settings.
Dealing with the same thing. On macOS 26, M4 Pro laptop, my brand new U2725QE connected via a Thunderbolt cable charges the Mac, but says no Thunderbolt signal.
Upgrading firmware from M2T101 to M2T102 and fingers crossed that'll fix it. Will report back.
These are Windows based instructions but I think you can translate them into macOS usage =
* Close/end task all unnecessary software applications (Browsers, Dell SupportAssist, Dell Update Application, Dell Display Manager, Dell Display and Peripheral Manager, Dell Color Management, Steam, Anti-virus, etc.)
* Open the Monitor OSD Menu * Go to Others * Go to Factory Reset and run it * Make sure DDC/CI is set to On * Exit the Menu
* Right click the firmware update file that you saved on the computer desktop * Click "Run as administrator" * Follow the prompts * When asked, restart the computer
Once the firmware update is done and the computer has restarted, do the following steps = * Turn the monitor off * Disconnect the power cable and video cable from the monitor. Wait 5 seconds * Reconnect the power cable and video cable to the monitor * Turn the monitor on
Maseer
1 Rookie
•
2 Posts
•
10 Points
0
0
Posted May 23rd, 2026 01:17
Fixed! Here's everything I did in order:
1. Updated the firmware to M2T102, connected to a Windows/PC
2. Unplugged ALL cables from the monitor (not just the power cable)
3. Waited 15 minutes
4. Held the power button on the monitor for 15 seconds to completely drain any left over power
5. Connected ONLY the power cable, and turned the monitor back on
6. Connected ONLY the Thunderbolt cable from the 140w port to the Mac, and switched the input source to Thunderbolt on the monitor. The Mac screen appeared!
7. Connected all other cables and adjusted the rest of the settings.