UNSOLVED

smakdown61

updated

23 years ago

Closed

S

smakdown61

10 Posts

0

8069

April 19th, 2004 22:00

Transferring hardware from latitude cp to latitude cpi r400gt

I am trying to transfer all the hardware from my latitude cp (hard drive, battery, pc cards, etc..) to a stripped down cpi r400gt that someone gave me. Everything seemed to fit fine except I found out that the r400gt takes sdram instead of the edo ram from the cp. Would this be the correct memory needed? http://www.oempcworld.com/Merchant2/merchant.mvc?Screen=PROD&Product_Code=128M-SO66LP&Category_Code=

Also, would i have any problems transferring the hard drive from the cp to the cpi (its running windows 2000)? As in needing to format it for any reason because it is being installed in a completely different computer (We are going from a p233mmx to a p2 400 processor).

 

  • smakdown61

    10 Posts

    156

    0

    Posted April 21st, 2004 20:00

    Anybody????
  • 156

    0

    Posted May 1st, 2004 04:00

    If I were you I'd grab a SODIMM you think will work from a local retailer with a generous return policy, test it out, then find some OEM with the same specs from Pricewatch (assuming you want to go the el-cheapo route).  Otherwise, do the same but get your memory from a reputable dealer.  I hear good things about Corsair and Kingston; I run mainly Mushkin in my desktops; I don't know if they make laptop RAM.  I haven't had any trouble with my off-brand 128's in this CPx.

    Your Win2k installation may or may not work.  Just give it a whack--pop the drive in there and see what happens.  If it boots, hooray.  Otherwise, just do a *reinstall* over the existing installation on that drive.  In my experience that will cause Winblows to re-recognize some important drivers that might cause your system not to boot (mainly ACPI stuff and storage/chipset drivers).

    Good luck!  I did the same with my setup--a CPi filled with goodies upgraded to a barebones CPxJ650 I got for a very nice price.